User manual LEICA CRF 1000

[. . . ] Close the cover again by turning it clockwise. If the Leica Rangemaster CRF is not going to be used for a long time, the battery should be removed. Batteries should be stored in a cool dry place. attention: · Batteries should never be put in a fire, heated, recharged, disassembled, or broken apart. [. . . ] Over 100 further measurements (at a progressively diminishing range) can be taken after the display first starts to flash. Use with and without glasses If you are not wearing glasses, leave the rubber eyecup (1a) folded up, as it comes (Figure A). This position gives the correct distance between the eye and the Leica Rangemaster CRF. When viewing with glasses, fold down the rubber eyecup (Figure B). Diopter compensation The diopter compensator allows you to adjust the sharpness of the target mark to suit you best. Simply target the Leica Rangemaster CRF on some far away object and turn the rubber eyecup (1a) until the target mark is as sharp as possible. The target mark can be seen by pressing the release button (3). The degree of compensation can be read off the "+" or "­" scale (1b) on the rubber eyecup. If the object is less than 10 m/11 yds away, out of range, or does not provide enough reflection, then "- - -" appears on the display. The Leica Rangemaster CRF switches itself off as soon as the display disappears. Scan mode With the Leica Rangemaster CRF, continuous measurements can also be made: If the release button (3) is held down the second time it is pressed, the unit switches to scan mode after approx. Spare parts If you should require any spare parts for your Leica Rangemaster CRF, e. Eyepiece cup or carrying cord, please contact our Customer Service department (address, see p. Problem Cannot get truly round view without dark edges Cause a) Viewer's pupil is not in ocular's exit pupil b) Eyecup position is not correct for use with / without glasses Diopter compensation setting is not perfect a) Target out of operating range b) Insufficient reflection from target Battery flat Remedy a) Correct the eye position b) When wearing glasses, fold down the eyecup, for viewing without, it should remain up (see p. Display not sharp "- - -" displayed when measuring Display flashes or no measurement possible 000 m/yds) / Objektive angle of view Exit pupil longitudinal distance (eyepoint) Prism system Coating on lens elements on prisms Diopter compensation Usable with glasses Operating temperature Storage temperature Watertightness Housing / Chassis material Maximum range Close focusing distance Measuring accuracy 7x 24 mm / 15 16 in / 3. Yes -10 to 55° C / 14 to 131°F -15 to 75° C / 5 to 167°F for 30 min: up to 1 m water depth carbon fiber reinforced plastic, soft lacquer coated / die-cast aluminum approx. 5 % beyond 732 m/800 yds 4-digit LED / available either in meter or yard version 1 3 V lithium cell type CR2 approx. 000 measurements at 20° C / 68° F invisible, eye-safe according to EN and FDA class 1 approx. Leica Academy Our seminars offer participants practical information on the Leica world of values and the fascination of skilled use of Leica products. More details, along with the current program of seminars, are available from: Leica Camera AG, Leica Akademie Oskar-Barnack-Str. 11 , D 35606 Solms Tel: +49 (0)64 42-2 08 421 Fax: +49 (0)64 42-2 08 425 la@leica-camera. Com Leica on the Internet Up to date information about products, novelties, special events, and the Leica company is available on our home page on the internet at: http://www. [. . . ] This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Equipment (VCCI). If this is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual. Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ]