User manual LEICA DISTO D3

[. . . ] Leica DISTO D3 TM The original laser distance meter TM Leica DISTOTM D3 1 2 4 6 8 11 11 19 13 15 12 14 16, 17, 18 MENU 3 5 7 9 10 10 1 2 4 3 5 6 7, 8, 9 TIMER a a b b ? UNIT RESET TRIPOD BEEP ONOFF max b min 20 21 22 23 27 24 28 25 29 26 30 User Manual English Congratulations on the purchase of your Leica DISTOTM D3 . Carefully read the Safety Instructions and the User Manual before using this product. The person responsible for the instrument must ensure that all users understand these directions and adhere to them. Safety Instructions Symbols used The symbols used in the Safety Instructions have the following meanings: WARNING: Indicates a potentially hazardous situation or an unintended use which, if not avoided, will result in death or serious injury. CAUTION: Indicates a potentially hazardous situation or an unintended use which, if not avoided, may result in minor injury and/or in appreciable material, financial and environmental damage. [. . . ] The next measurement is subtracted from the previous one. This process can be repeated as required. The result is always shown in the summary line with the previous value in the second line. The last step is cancelled. Volume Press this button twice. symbol Press this button to take the first length measurement (e. g. Press this button to take the second length measurement (e. g. Press this button to take the third length measurement (e. g. The volume then appears in the summary line. Press the button for longer to display additional room information such as ceiling/floor area, surface area of the walls, circumference. Area Press once. symbol appears in the Tilt measurement The inclination sensor measures tilts between ± 45°. During tilt measurement the instrument should be hold without a transverse tilt (± 10°). Press this button once to activate the tilt sensor. The tilt is continuously shown as ° or % depending on the setting. Press to measure the inclination and the distance. See figure {J}. Press this button to take the first length measurement (e. g. Press it again to take the second length measurement (e. g. The result is displayed in the summary line. Press the button for longer to calculate the circumference. Functions 10 Leica DISTOTM D3 760150 gb Direct horizontal distance Press this button twice and the following symbol appears in the display . Press this button to measure tilt and distance. The summary line displays the result as the direct horizontal distance. Stake out function Two different distances (a and b) can be entered into the instrument and can then be used to mark off defined measured lengths, e. g. Entering stake out distances: Press this button four times and the stake out a function symbol appears in the display b . b D GB F I E P NL DK S N FIN J CN ROK PL H RUS CZ Room corner angle function The angles in a triangle can be calculated by measuring the three sides. Press this button three times and the room corner symbol appears in the display . [. . . ] The timer can be used for all measurements. Recalling the constant Press this button once to recall the constant and make it available for further calculations by pressing button . Historical storage Press this button twice and the previous 20 results (measurements or calculated results) are shown in reverse order. The and buttons can be used for navigation. Press this button to use a result from the summary line for further calculations. Pressing the and buttons at the same time erases all the values in historical storage. Appendix Message codes All message codes are displayed with either "Error". [. . . ]