User manual LEISURE H 101 PK

[. . . ] Up to 6 Gigaset Repeater units can be used with a single base station thus making available extra extended reception range for each 2 handsets respectively. The maximum number of handsets that can be registered at your base station is not affected by the Gigaset Repeater. Base station Example with 2 Gigaset Repeaters Additional reception ranges with Gigaset Repeater Before you start to register the units, install the Gigaset Repeater in close proximity to the base station and a power supply point. If a Gigaset Repeater is already in use, it must be switched on and positioned next to the base station before registration can commence. 14 01. 07. 2010 Grep-eng. fm Gig Repeater, IM: A31008-M601-R101-3-SU19 Preparing Socket for power lead The power lead supplied is plugged into the socket on the Gigaset Repeater’s rear side. Using the specified measurements, drill the necessary holes in the wall to mount the device using the screws and plugs supplied. The different operating modes are indicated on the front of the Repeater unit by means of two LED’s (for an explanation, see page 17). LED’s Preparing Please refer to the user guide for your phone to check whether your base station is suitable for operating the repeater and how to prepare it for registering the repeater. Registration Carry out the following steps: $ Switch off the Gigaset Repeater (disconnect the power plug). [. . . ] Please refer to the operating instructions for your base station. Ensure that other base stations close to the Gigaset Repeater are not in registration mode during this process. $ Switch on the Gigaset Repeater (connect the power plug). The left LED on the Gigaset Repeater flashes continually. After a short while the LED stays on permanently indicating that registration is complete and that the unit is ready for operation. The Gigaset Repeater can be registered independently of the length of an audible registration tone or a display at the base station. If registration is not successful, the LED on the Gigaset Repeater will flash continuously. In this case, repeat the procedure. 15 ENGLISH 01. 07. 2010 Grep-eng. fm Gig Repeater, IM: A31008-M601-R101-3-SU19 Installation Repeating registration You can reregister the Gigaset Repeater at any time, for example if initial registration was unsuccessful, or if the Gigaset Repeater is to be registered at another base station for the first time. Before registering the Gigaset Repeater once again (e. g. at a different base station), please reset the Gigaset Repeater beforehand as described below: ● ● ● $ $ $ Switch off the unit (disconnect the power plug) Switch on for 1 to 5 seconds and switch it off again Switch on for 25 to 35 seconds and switch it off again. The Gigaset Repeater is now ready to be registered again as described above. This is signalled by the LED which flashes continually once the power plug is reconnected. Installation Once you have registered your Gigaset Repeater you can install it wherever you would like to extend the reception range of your handsets. However, you must ensure that there is a power point at the place of installation and that the left LED remains on constantly after the device has been switched on. If the left LED flashes, the Gigaset Repeater is too far away from the base station or reception is being hindered by thick walls or metal objects for example (e. g. When looking for a suitable installation site, a useful guide is a handset which requires a good connection with the base station at the Gigaset Repeater installation site. ● The above provisions does not imply a change in the burden of proof to the detriment of the customer. To invoke this Guarantee, please contact the Gigaset Communications telephone service. The relevant number is to be found in the accompanying user guide. 19 ENGLISH 01. 07. 2010 Grep-eng. fm Gig Repeater, IM: A31008-M601-R101-3-SU19 Miscellaneous Guarantee Certificate Ireland Without prejudice to any claim the user (customer) may have in relation to the dealer or retailer, the customer shall be granted a manufacturer’s Guarantee under the conditions set out below: ● In the case of new devices and their components exhibiting defects resulting from manufacturing and/ or material faults within 24 months of purchase, Gigaset Communications shall, at its own option and free of charge, either replace the device with another device reflecting the current state of the art, or repair the said device. In respect of parts subject to wear and tear (including but not limited to, batteries, keypads, casing), this warranty shall be valid for six months from the date of purchase. ● This Guarantee shall be invalid if the device defect is attributable to improper care or use and/or failure to comply with information contained in the user manuals. In particular claims under the Guarantee cannot be made if: ● The device is opened (this is classed as third party intervention) ● Repairs or other work done by persons not authorised by Gigaset Communications. ● Components on the printed circuit board are manipulated ● The software is manipulated ● Defects or damage caused by dropping, breaking, lightning or ingress of moisture. This also applies if defects or damage was caused by mechanical, chemical, radio interference or thermal factors (e. g. : microwave, sauna etc. ) ● Devices fitted with accessories not authorised by Gigaset Communications ● This Guarantee shall not apply to or extend to services performed by the authorised dealer or the customer themselves (e. g. installation, configuration, software downloads). User manuals and any software supplied on a separate data medium shall be excluded from the Guarantee. ● The purchase receipt, together with the date of purchase, shall be required as evidence for invoking the Guarantee. [. . . ] ● The purchase receipt, together with the date of purchase, shall be required as evidence for invoking the Guarantee. Claims under the Guarantee must be submitted within two months of the Guarantee default becoming evident. ● Ownership of devices or components replaced by and returned to Gigaset Communications shall vest in Gigaset Communications. ● This Guarantee shall apply to new devices purchased in the European Union. [. . . ]