User manual LENCO CR-2800

[. . . ] STEREO RADIO CD/USB/SD/MMC/MP3 PLAYER WITH DUAL ALARM CLOCK SYSTEM CR-2800 INSTRUCTION MANUAL IMPORTANT SAFETY INSTRUCTIONS WARNING: TO PREVENT FIRE OR SHOCK HAZARD DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. This lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons present. Warning: to reduce the risk of electric shock, do not remove or open the casing of the product. There are no user serviceable part inside. Refer servicing to qualified service personnel. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION: Please read through these instructions, so you will know how to operate your equipment properly. [. . . ] Press the WEEKEND button to cancel this function, and return to your preset alarm(s). -4- Dimmer Control The display DIMMER selector switch located on the right side cabinet was set to the HIGH position at our factory. If you find the display to be too bright for sleeping, slide the DIMMER selector switch to the LOW position. Sleep To Music Timer You can use the sleep timer to fall asleep to the Radio, CD player or USB/SD/MMC music up to 90 minutes and have the unit shut off automatically. 1) Press the ALARM OFF/POWER button to turn the power On . Operate the Radio, USB/SD/MMC music or CD player as usual. WARNING: The level you select for Sleep To Music is the same level you will hear when the alarm turns On in the morning. 2) Press the SLEEP button to select the desired amount of sleep timer from 90 minutes to one minute. 3) When the display shows the desired amount of time, stop pressing the SLEEP button. After 5 seconds the display changes back to the correct time. The Radio, CD player or USB/SD/MMC music will continue until the sleep timer counts down to 00 and then shut off automatically. 4) To stop the Radio or CD player before the sleep timer counts down to 00 , press the ALARM OFF/POWER button to turn the unit Off . Note: If you are falling asleep to CD or USB/SD/MMC, the sound stops when the disc ends, even if a longer sleep time was selected. Listening To The Radio 1) Press the ALARM OFF/POWER button to turn the unit On . 2) Press the FUNCTION button until the FUNCTION indicator turns off to select the Radio function. 3) Rotate the TUNING control on the right side panel to tune to the desired station. Press the ST/MONO button if the received program is too noisy. 4) Rotate the VOLUME control on the left side panel to adjust the volume level. 5) When you are finished listening press the ALARM OFF/POWER button to turn the unit Off . Playback will begin on the selected track. 8) To stop playback at any time press the STOP button. After the last track has played the disc stops automatically. Press the OPEN/CLOSE button to open the CD door and remove your disc. [. . . ] Repeat steps 2 & 3 to store other desired tracks until all tracks programmed. Press the PLAY/PAUSE button to start playback from the first programmed track. Press the STOP button to stop program playback. Note: Switch the unit to SD playing mode, follow the above steps to proceed PROGRAM TRACKS ON SD/MMC CARD. [. . . ]