User manual LENCO CR-333

[. . . ] CR-333 OWNER S MANUAL Dual Alarm AM/FM Clock Radio with Triple Display, Touchless Snooze and Display Control and SmartSet ® Automatic Time Setting System TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. IMPORTANT SAFETY INSTRUCTIONS 1. ) Read these instructions. 2. ) Do not use this apparatus near water. 4. ) Do not block any ventilation openings. [. . . ] To manually adjust the time display depress and hold the TIME button, and press either the SET (Up) or (Down) buttons to adjust the time display ahead or back as desired. Each press of the SET (Up) or (Down) buttons will change the display by one minute. If you hold the SET (Up) or (Down) buttons the display will continue to change. The display will change slowly at first, one minute at a time. But if you continue holding the SET (Up) or (Down) buttons the display will change rapidly. NOTE: If you manually adjust the time, your new setting is entered into the SmartSet® memory. If the power is interrupted, the display will return to your new setting, not the original setting, when the power is restored. Adjusting The Wake Up Times Your SmartSet® clock radio has two separate alarms that can be set and used independently. You may use the alarms to wake two people at different times, or you may use one alarm for weekdays and the other for weekend wake up times. The procedure for adjusting the wake up time is the same for both Alarm 1 and Alarm 2. 1. ) Depress and hold either the ALARM 1 or ALARM 2 setting button. 3. ) Press the RADIO ON/OFF button to turn the radio On . 4. ) Select your desired station with the TUNING control. 5. ) Adjust the VOLUME control to the desired setting. 6. ) When you are finished listening, press the RADIO ON/OFF button to turn the radio Off . The radio dial pointer light goes off. Antenna Information AM The AM bar antenna is inside the cabinet. If AM reception is weak, change the position of cabinet until the internal antenna picks up the strongest signal. FM The FM antenna is built in to the AC power cord. If FM reception is weak try varying the position and direction of the power cord until you find the strongest signal. Wake To RADIO 1. ) Turn the radio On and select the Band, Station, and Volume level that you wish to hear when the alarm comes on, then turn the radio Off again. 2. ) Reconfirm the wake up time and alarm mode settings for the alarm you are using, Alarm 1, Alarm 2, or both Alarms. 3. ) Set the ALARM selector switch for one or both alarms to the RADIO position. The appropriate ALARM 1 and/or ALARM 2 display will change from OFF to the selected wake up time. 4. ) At the selected wake up time the radio will turn On . It will play for one hour and then shut off automatically. [. . . ] If the unit is disconnected from the AC outlet after the battery is exhausted, or if a power interruption occurs, the SmartSet® memory will be lost and the clock will need to be reset when the power is restored. Be sure to install a fresh lithium battery before you reset the clock, otherwise the clock will need to be reset each time the power is interrupted. If the lithium battery is exhausted and you experience an interruption in the AC power supply, the clock will reset itself to its initial default setting when the power is restored. The initial default setting is 12:00 AM, SATurday, January 1st (1. 01), 2005. If you notice that the time on your SmartSet® clock radio is completely incorrect, and the DAY OF WEEK indicator is also wrong, press the CALENDAR button. [. . . ]