User manual LENCO DVL-2453 WHITE

[. . . ] 24" (61cm) LED TV with DVD & DVBT Model No. : DVL-2453 WHITE For information and support, www. lenco. eu Contents 1-3 SAFETY INFORMATION 4 5-6 7 8-11 12 13 14 15-22 Unit Remote Control Aerial connection Connecting external devices Common Interface slot Auto installation setup Source menu Menu settings 23-29 DVD Operation 30 31 TROUBLE SHOOTING GUIDE TECHNICAL SPECIFICATIONS options SAFETY INFORMATION IMPORTANT SAFETY INSTRUCTIONS - READ CAREFULLY BEFORE USE. Take note of the following safety information which appears on the back of the TV. CAUTION TO PREVENT ELECTRICAL SHOCK, DO NOT REMOVE ANY COVER SCREWS, NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This symbol indicates that there are important operating maintenance instructions in the literature accompanying this unit. This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. Keep these instructions · · · · · · · Do not use this TV near water. Install in accordance with the supplied Quick Start Guide and this User Guide. [. . . ] Make sure to establish the required connection. Make sure that the connectors are properly and correctly attached before connecting the appliances to the power supply. 8 Connecting external devices (continued) PC connection As PCs are sometimes still supplied with a `conventional' CRT monitor, you may need to adjust the display settings of your PCs graphics card, otherwise the pictures may not appear correctly. Switch on your PC (still with your original monitor connected) no w select the screen resolution, and select 60Hz refresh rate. Switch off your PC, then connec t it to your TV while both appliances are still switched off. VGA, HDMI PC Connection Use a PC-VGA cable (not supplied) to connect the TV to your PC. You can also use an HDMI cable to connect to your PC (if your PC Graphic card supports HDMI). When the HDMI cable is used, the PC audio cable is no longer required. If you use the HDMI to DVI cable, you will need to use the PC audio cable. Contact your Pay Per View TV service provider to get more information about the modules and subscriptions. NOTE: Conditional Access Module and Smart Cards are sold separately. WARNING!SWITCH OFF YOUR TV BEFORE ANY MODULE IS INSERTED INTO THE COMMON INTERFACE SLOT, THEN ADD THE SMART CARD TO THE CAM. 1. Turn on the TV and ensure `DTV' Source is selected. If the CAM is detected the TV will display the following message on the screen. "Common Interface Module inserted" wait for a few moments until the card is activated. Select the relevant digital Pay Per View channel. Detailed information on the Smart Card in use is displayed 5. Press the Ok button to access the card menu. Refer to the Module Instruction Manual for setting details. When the module is removed, the following message will appear on the screen. "Common Interface module removed". 12 Auto installation setup Power On / Off the LCD TV 1. Connect to the power supply with a power code and an adaptor. -To turn on the TV Press POWER button on the TV or remote control. -To turn off the TV Press POWER button on the TV or remote control. When you initially turn on the LCD TV you will see the first time installation menu as below: Ensure that the aerial is plugged in to the TV, Make sure your Remote is in TV mode (by pressing INPUT button), switch on the TV by pressing POWER. [. . . ] Adjust the vertical position of the screen. Adjust the pixel clock frequency, until the image size is maximized for the screen. Adjust the phase of the ADC sampling clock relative to the sync signal, until a stable image is obtained. Press button to setup the parameter of the screen automatically. 22 INPUT 23 24 25 26 DVD-SETUP / / / / 27 OK / / / 28 1246793 35 3 59 58  124 8 F 9 2 ! [. . . ]