User manual LENCO IPD-5200

[. . . ] Connecting a power supply with a different rating will cause permanent damage to the radio and may be hazardous. The display on the front of the radio will light up and say: Reciva Enabled ARM Powered Followed by: Initializing Network If you listen to the Internet radio and Media player before you turned off the radio, it will be automatically switched to Internet radio mode; Or if you was listening to FM radio, it will be automatically switched to FM radio mode. After a few seconds, this will change to show: Connecting to Network Step 2- Connect to network connection: Note: If you make a mistake at any point, press the BACK button to go back to the previous screen. Note: At first, you need to select network; (1)Press the SELECT button; (2)Press Tune up or down until the display says "Configure"; Configure (3) Press the SELECT button; (4) Press Tune up or down until the display says "Network Config"; Network Config 2 (5)Press the SELECT button; (6) Press Tune up or down until the display says "Wired/Wireless"; Wired/ Wireless (7) Press the SELECT button; (8) Press Tune up or down until your appropriate equipment; there is Auto, Wired Only, Wireless Only Options. Auto Wired Only If you select Auto, it will be select automatically. If you select Wired Only, It will be only used for Wired Ethernet. [. . . ] The radio will continue to display `[Empty]' if no UPnP servers and found. Select your UPnP server, by pressing Tune Up or Down if there is more than one UPnP server, and then press SELECT (note, your radio will display' Access Denied' at this stage) 4. Your PC will now prompt you that a device has attempted to connect to your UPnP server. In order to allow the radio to have access to the media files, you will need to click the `Library' tab from Windows Media Player 11 and select the `Media Sharing. . . ' item to open the `Media Sharing' window. Selecting `Media Sharing. . . ' for Windows Media Player11 : c. 14 5. From the `Media Sharing' windows , the radio will be listed as an unknown device. Click on the unknown device listed, then click the `Allow' button and then click `OK'. Allowing the Radio to Connect: Note: When you were playing, you were able to change the mode of playback via selecting Media Player/Playback Mode. 15 Configure Menu Choosing the option you want from the Configure Menu 1. ( Note: If you make a mistake at any point , press BACK button to go back to the previous screen. ) 2. Press Tune Up or Down until `Configure' is displayed 3. Press Tune Up or Down until the display shows the option you want. The radio gets into its `inactive' state when there is no user activity for 30 seconds. The `active' state is when there is user activity. `Standby' is the state when the radio has been turned off 2. Press Tune Up or Down to highlight the desired menu mode and press SELECT. The radio will now display the current backlight value for the menu mode. You can alter this value by pressing Tune Up or Down to increase or decrease it. <WiFi Strength> Selecting this option will see the WiFi strength of Receiver; After select the `WiFi Strength ' menu item, the radio will display its the WiFi strength of Receiver in percent . 17 Configuring `My Stuff' Registering an account on Reciva's website 1. Open the website, http://www. reciva. com, from your internet browser. Click on the `My Account' link and follow the on-screen instructions to register an account. Please note, during the registration process, a validation code will be sent to you via email. Please enter this code when prompted to do so. [. . . ] If you are experiencing these problems, you will need to contact your broadband supplier. When playing a stream, the Internet Radio/Media player, downloads a small amount of the stream before it starts playing. This is used to fill in any gaps in the stream that may occur if the internet or the wireless network is busy. The Internet Radio streams music data from the PC while you are listening. [. . . ]