User manual LENCO IR-2100

[. . . ] User Manual IR-2100 Internet / FM Radio Please read this user manual carefully before using the receiver Location of Controls 1. Reply (reserved for future function) 12. Tune Up 1 SETTING UP Please follow those steps for connecting your radio to your network Step 1- Switching on the radio; Plug the cable from the AC Cord into the socket on the back of the radio, then switch on at the mains. Caution: Only use the AC Cord that supplied with the radio. [. . . ] Press the SELECT button to choose the option shown on the display. <Network Config> Enables you to configure your radio's network settings, scan again for a connection to another wireless network , or to manually configure the network parameters. This is useful if you take the Internet radio to another building where you want to use. Once the radio has established a certain type of connection to the network, then this type of connection will remain in use while the radio is on. <Version> Displays the versions numbers of the various parts of software the hardware on you Internet radio. <Firmware Upgrade> Use this option to download new firmware for the radio from the Reciva portal on the internet. If there is new firmware available, the radio will prompt you if you want to download it or not. Note, at this stage, you can press the radio's BACK button to cancel the radio beginning a firmware upgrade. A firmware upgrade may take several minutes, so do no switch off the power to the radio until the operation is complete otherwise the radio may become permanently damaged. <Language> Allows you to change the display language. <Factory Reset> Puts all the setting back to their default as they were when they left the factory. If you perform a factory reset on your radio you will loss all you presets and your wireless network connection. <Register> This will display a key that can be used to register the radio on the Reciva Customer portal. <Clock> Use this option to set the time, to set an alarm and to view the current alarm setting, see'' Setting the clock'', `'Setting the alarm''. <Sleep Timer> Selecting this option will enable the Internet radio to switch itself off after a set period. After selecting the `Sleep Timer' menu item, the radio will display: ` Sleep Timeout' and the sleep timer value in the form '00:00:00'(hours : minutes : seconds). Press Tune Up or Down to change to sleep timer value and then press SELECT to begin the sleep timer. The radio will continue to play as normal, but it will go into standby mode after the sleep timer has expired. To turn the radio back on again, simply press the ON/OFF button. <Backlight> Selecting this option will alter the internet radio's backlight values. 16 1. After select the `Backlight' menu item, the radio will display its list of three menu modes: `Inactive', `Active' and `Standby'. These three states are explained below: . [. . . ] If a stream gets blocked or experiences Internet congestion while transferring it may stop/interfere with the quality of play. If this happens, check your internet connection speed- it must be faster than the speed of the streams. Software Licence information This product contains software licensed under version 2 of the GNU public license and version2. 1 of the GNU Lesser Public License, The source code for this software is available from: http://www. reciva. com/gpl/ This product includes technology owned by Microsoft Corporation and under a licence from Microsoft Licensing GP. Use or distribution of such technology outside of this product is prohibited without a license from Microsoft Corporation and/or Microsoft Licensing, GP as applicable. [. . . ]