User manual LENCO MDV-3

[. . . ] MDV-3 Home Cinema Set -1- FORW AWRD WELCOME Thank you for purchasing this product. It is recommended that you read this instruction manual before use to ensure safe and enjoyable operation. PLEASE Please unpack carefully, and keep all the accessories in the same place. Do not place objects filled with liquids, such as vases, on this unit. Do not place naked flame sources, such as lighted candles on this unit. [. . . ] Press the button again to stop searching. Save Bands Press the Save button, will appear on the VFD, that means that saving the current frequency of band. For example: If you want to save 99. 3 MHz in 28th, please press 10+ button twice, 8 button once, then press T/F button to input 993, then press Save button to save this frequency. Soundtrack Selection Press L/R(MO/ST) button, you may select Mono and Stereo soundtrack output in FM status. When you select Stereo, the VFD will display Stereo. Exit FM/AM Status Press the Play/Enter button to exit FM/AM status and enter the disc playing. If the signal is not strong enough, you cannot select Hints for better Reception: Please vary the direction of the antenna to find the strongest signal for each station. - 15 - MENU SETUP Press the Setup button on the remote controller to open the menu setup function, the TV screen will display the following figures, SYSTEM SETUP PAGE 1). TV System perform adjustment according to different disc applicable for different TV system, includes four options: NTSC, PAL, PAL60, AUTO. Screen Saver this option is used to open or close screen saver program, includes: ON and OFF. Video Output according to your requirement, you can input different video source, includes 5 modes: INTERLACE-YUV, S-VIDEO, P-SCAN, S-VIDEO, PC-VGA (1) (2) INTERLACE-YUV: this option can be chosen if Y, Cb, Cr are connected with TV P-SCAN: this option can be chosen when Y, Pb, Pr are connected with TV and the TV is set in P-SCAN mode. NOTE: only when the TV has progressive scan function, you can use P-SCAN. TV Type please select the right screen type according to your TV, including 3 options, 4:3 LB: mailbox format, the picture data will panoramic and scanning format will be played in this format. 1) 4:3 PS: for regular TV, the picture data with panoramic and scanning format will be played in this format. 2) 16:9: for wide screen TV, to be played in full size. (Meanwhile, it is necessary to set the TV to FULL status. ) (Fig. 3) As shown above, each screen type is presented by one example. Such setting will not affect the normal size of the picture data. - 16 - MENU SETUP 5). Password and Rating The password is used to prevent the children watching unproper discs. (3) press the direction buttons to exit. Note: you cannot play the discs with a rating higher than your set rating, unless input the correct password upon the system prompt. Note: rating selection can be done only when the password lock is open. And only when the password lock is locked, the rating restriction can take effect. [. . . ] Press the direction button System Setup as shown in the following figure: to switch over to the interface for 2. Press the direction button direction button to move the cursor to the Password option, press the or Play/Enter button to enter the subdirectory, then use the number button to enter the password(the password upon delivery is 0000 ). Press the Play/Enter button for confirmation. After finished the setup of password, press the direction button Rating option. [. . . ]