User manual LENCO RC-8-2

[. . . ] P. 1 (1) IR (Infra-red) Transmission IR is being "sent" or "received". (2) Device keys These device keys select the device to be controlled. (3) POWER key The POWER key controls the same function as on your original remote control. (4) Number keys The number (1-9, 0, 11, 12) keys provide functions just like your original remote control. [. . . ] Press the [CH+/-], [VOL+/- * * ], *, and other applicable keys. In any cases if you need to leave the quick/manual search, just press the [ESC] key to exit, the LCD will be shown as EXIT and back to normal operation mode. 11. To program other equipment, repeats the Steps 1-9 for your VCR, SAT, AUD and or your second TV or VCR or SAT. Press the [SET] key to for 2 seconds Press & release the [CH+] Press the [SET] key once Press the [DEVICE] key to select a desired mode Press the [SET] key to save the working code P. 5 SETTING UP BY LEARNING The RC-8-2 comes with a complete library of pre-programmed codes. After you have set up the RC-8-2 for your device, you may find that there are one or more keys that you had on the original remote control, which do not have a place on the RC-8-2 keypad. The RC-8-2 offers a special learning feature that allows you to copy almost any function from your original remote control onto the keypad of the RC-8-2. Except to the Macro keys, [SET] key and Device mode keys. Before you start : ?Make sure your original remote control is working correctly. ?Make sure neither your RC-8-2, nor your original remote control is pointing at your device. To Learning (direct) : For example: To copy the "PIP" function from your original TV remote control onto the "I I" key of your RC-8-2. Place the RC-8-2 and your original remote control on a flat surface. Make sure the ends which you normally point at your device are facing each other. Point the original remote to the front center head of the RC-8-2 (see picture below). Keep the remotes at a distance of 2 to 5 cm. Press the [SET] key to for 2 seconds and the LCD will be shown CODE SETUP. Press & release the [CH+] key for two (2) times to view the LEARN MODE page. Upon the LCD shown as LEARN MODE, press the [SET] key once. Press the [Device] key to select a desired mode (TV, VCR, SAT or AUD, etc. . ). Press the [SET] key once and the RC-8-2 LCD shown as TV LEARN KEY. Press the "I I" key on the RC-8-2 remote where you want to place the learned function, the LCD shown as TV LEARNING. Press & hold the key that you want to copy (Example: PIP key on your original remote control). After learning is OK, the LCD shown as SUCEESS for 3 seconds then shown as TV LEARN KEY. [. . . ] Press the [SET] key to for 2 seconds Press & release the [CH+] key for seven (7) times Press the [SET] key once Press the [SET] key to enter MAC1 operation To store the MAC1, press the [SET] key to confirm P. 9 RESET ALL SET UP The RC-8-2 provides the reset all setup to let you back to the internal setup to the factory default setting. Press the [SET] key to for 2 seconds and the LCD will be shown CODE SETUP. Press & release the [CH+] key for eight (8) times to view the RESET ALL page. Upon the LCD shown as RESET ALL, press the [SET] key once. [. . . ]