User manual LENCO TFT-2402

[. . . ] Check with your Local Authority or retailer for recycling advice (Waste Electrical and Electronic Equipment). This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit. This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit. Do not install the unit in an unstable space. [. . . ] press it again to display the content of the page again. Number buttons 0~9 on the remote control can be used to get to a certain page. "o/p" button on the remote control can be MENU used to display the content of previous or next page. press the RED/GREEN/YELLOW/CYAN button on the remote control , the page of relevant color displayed on the lower part of the screen will be displayed. : Press this button if you want to enlarge the content on the upper part of the page, and press the second time to enlarge the content on the lower part of the page, and the third time to resume normal display of all the contents on the page. OK : Press this button if you want to display the concealed text. Press it again to close the display of concealed text. : Press this button if you want to display the index for all the teletext page. FAST TEXT: The RED, GREEN, YELLOW & CYAN buttons are used for quick access to color coded pages transmitted by FAST TEXT broadcast. Note: To cancel the first time installation during it's installation process, press [p] to select "NO", below screen appears: To cancel clearing channel search , press [MENU]. First time installation is not finished!Note: The first time installation screen appears again, when the "reset" operation has been done, and then turn off and turn on the main unit. Make sure all necessary connections are correctly connected before turn on the power. The power indicator turns red and the unit is in the standby mode. Turn on the connected necessary external device. Turn on the power press [z] to turn on the main unit. Turn off the power Press [z] again can turn off the main unit. the unit is automatically set standby mode. The sleep timer automatically switches off the power after a preset time has elapsed. There are 9 time periods available, press [SLEEP] on the remote control repeatedly to select the desired sleep time: 0 Min v 15 Min v 30 Min v 45 Min v60 Min v 75 Min v 90 Min v 105 Min v 120 Min (The sleep timer starts when the setting is finished. ) To check the remain sleep time Press [SLEEP] on the remote control, the remain sleep time appears on the screen for a few seconds. This operation do no effect to the channels without NICAM signal. [. . . ] multi devices plug into the same one AC outlet collections. Plug the power cord into another AC outlet. an incorrect sound system mode is setted. Set a correct sound system from the main menu to match your TV. [. . . ]