User manual LENOVO THINKPAD X230 (NZDAJFR)

[. . . ] User Guide ThinkPad X230 and X230i Notes: Before using this information and the product it supports, be sure to read and understand the following: • Safety, Warranty, and Setup Guide • Regulatory Notice • “Important safety information” on page vi • Appendix E “Notices” on page 171 The Safety, Warranty, and Setup Guide and the Regulatory Notice have been uploaded to the Web site. LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant a General Services Administration “GSA” contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. Using an ExpressCard, a flash media card, or a smart card . Notice on deleting data from your hard disk drive or solid-state drive . [. . . ] Observe the following guidelines: • Replace the hard disk drive or solid-state drive only if you upgrade it or have it repaired. The connectors and slot of the hard disk drive or solid-state drive are not designed for frequent changes, or drive swapping. € Do not drop the drive or subject it to physical shocks. Put the drive on a material, such as soft cloth, that absorbs any physical shocks. € Do not apply pressure to the cover of the drive. € Before removing the hard disk drive, make a backup copy of all the information on it, and then turn the computer off. € Never remove the drive while the computer is operating, in sleep mode, or in hibernation mode. To replace the hard disk drive or solid-state drive, do the following: 1. Turn off the computer, then disconnect the ac power adapter and all cables from the computer. Close the computer display, and turn the computer over. See “Replacing the battery” on page 69. Loosen the screw that secures the slot cover. Remove the hard disk drive or solid-state drive by pulling out the tab. Detach the side rubber rails from the hard disk drive or the side spacer rails from the solid-state drive. Attach the side rubber rails to the new hard disk drive or the side spacer rails to the new solid-state drive. Insert the new hard disk drive or solid-state drive into the slot. Reinstall the slot cover and tighten the screw to secure it. See “Replacing the battery” on page 69. Connect the ac power adapter and all cables. Replacing a memory module Before you start, print these instructions. Replacing devices 75 Note: The operating speed of the memory module has dependency on the system configuration. In some conditions, the memory in your computer might not be able to operate at the maximum speed. [. . . ] The furnishing of this document does not give you any license to these patents. You can send license inquiries, in writing, to: Lenovo (United States), Inc. Some jurisdictions do not allow disclaimer of express or implied warranties in certain transactions, therefore, this statement may not apply to you. This information could include technical inaccuracies or typographical errors. [. . . ]