User manual LENOVO THINKVISION LT1913P (60AAHAT1EU)

[. . . ] LT1913p Flat Panel Monitor User’s Guide Product numbers 60AA-HAR1-WW First Edition (June 2013) © Copyright Lenovo 2013. LENOVO products, data, computer software, and services have been developed exclusively at private expense and are sold to governmental entities as commercial items as defined by 48 C. F. R. 2. 101 with limited and restricted rights to use, reproduction and disclosure. LIMITED AND RESTRICTED RIGHTS NOTICE: If products, data, computer software, or services are delivered pursuant a General Services Administration "GSA" contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. [. . . ] Monitor specifications for type-model 60AA-HA*1-** Video input (DVI) Interface Input signal Horizontal addressability DVI VESA TMDS (Panel Link™) 1280 pixels (max) -- Vertical addressability 1024 lines (max) Clock frequency Communications Supported Display Modes VESA DDC Horizontal frequency Vertical frequency Native Resolution Temperature Operating Storage Shipping Humidity Operating Storage Shipping 165 MHz CI 30 kHz - 83 kHz 50 Hz - 76 Hz 1280 x 1024 at 60 Hz 0° to 40° C (32° to 104° F) -20° to 60° C (-4° to 140° F) -20° to 60° C (-4° to 140° F) 10% to 80% non-condensing 5% to 95% non-condensing 5% to 95% non-condensing Chapter 3. 3-2 Troubleshooting If you have a problem setting up or using your monitor, you might be able to solve it yourself. Before calling your dealer or Lenovo, try the suggested actions that are appropriate to your problem. Troubleshooting Problem The words "Out of Range" are shown on the screen, and the power indicator is flashing green. Possible cause The system is set to a display mode which is not supported by the monitor. Suggested action If you are replacing an old monitor, reconnect it and adjust the display mode to within the specified range for your new monitor. If using a Windows system, restart the system in safe mode, then select a supported display mode for your computer. If these options do not work, contact the Support Center. The video signal cable is not connected with the monitor or system completely. The automatic image setup function was not performed. The power indicator is not lit and there is no image. • The monitor’s power switch is not switched on. The power cord is loose or disconnected. Be sure the signal cable is firmly plugged into the system and monitor. Select another color setting from the OSD menu. • Be sure the power cord is connected properly. Press any key on the keyboard or move the mouse to restore operation. Check the Power Options settings on your computer. "Understanding power management"on page 2-9 "Connecting and turning on your monitor"on page 1-5 "Adjusting your monitor image"on page 2-3 "Adjusting your monitor image"on page 2-3 "Connecting and turning on your monitor"on page 1-5 Reference "Selecting a supported display mode"on page 2-7 • • • • • • Screen is blank and power indicator is orange. The monitor is in Standby/Suspend mode. • • Chapter 3. 3-3 Table 3-2. Troubleshooting Problem The power indicator is orange, but there is no image. Possible cause The video signal cable is loose or disconnected from the system or monitor. The monitor brightness and contrast are at the lowest setting. One or more of the pixels appear discolored. [. . . ] The products described in this document are not intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. The information contained in this document does not affect or change Lenovo product specifications or warranties. Nothing in this document shall operate as an express or implied license or indemnity under the intellectual property rights of Lenovo or third parties. All information contained in this document was obtained in specific environments and is presented as an illustration. [. . . ]