User manual LENOXX 1135

[. . . ] Your cassette radio requires a DC input of 3V (300 mA or more ) with a XXXXX polarity. This AC Adapter can be purchased separately in many radio stores. RADIO OPERATION NORMAL TUNING 1. Insert the headphone plug into the Headphone jack. Unbunch the headphone wire because this is also your FM Antenna. [. . . ] Insert a pre-recorded tape into the slots on the door with the open surface facing up. Set the Function switch to TAPE position. Turn the Volume Control to the desired level. Set Bass Boost switch to ON if an emphasized bass level is desired. The tape will play till the end and the set will shut itself off. To listen to the other side, remove the tape, flip it over to the other side, re-insert and press Play. Press the Stop button to stop playing the tape. 4 1135110298 E FAST FORWARD Press Fast Forward button (15) to advance the tape. Release the button by pressing Stop. POWER To turn radio on, slide Radio/Tape switch (1) to RADIO. To shut the radio off, slide switch TAPE. To turn tape on, slide switch to TAPE (radio off) position and press Play. When the tape reaches the end and Play button pops up, the power is off. LOCK SWITCH Sliding the Tune Lock switch ON (up) disables the Front panel (door) buttons. This prevents accidentally tuning to a different station. BASS BOOST SWITCH Sliding this switch to ON gives you more bass ( low frequency ) sounds in radio or tape. FM STEREO SWITCH Sliding the switch to FM STEREO ON (stereo) will give you stereo sound and stereo indicator will show in the display window. However, some FM Stereo stations are noisy, so you may want to switch to OFF (mono) for clearer sound in some locations. NOTE: To avoid damaging the tape head, do not open the cassette door in the play mode. Press Stop first. ANTENNA The AM Band has a built-in ferrite rod antenna. The FM Antenna is built-in to headphone wire so be sure to extend the headphone wire for best reception. You may find you can improve AM reception by rotating the set or bringing it closer to a window. 5 1135110298 E CASSETTE TAPE OPERATION TIPS 1. To obtain good operation, the head should be cleaned after every 30 hours of use. It is also recommended that the tape be kept away from excessive heat or cold. If there is slack in the tape, remove it before inserting the tape. To do so, insert a pencil into the hub and rotate clockwise as shown. 3. Keep the tape head clean since a dirty tape head can cause distorted sound or improper tape speed. [. . . ] This warranty does not cover broken antenna or cabinet. UNDER NO CIRCUMSTANCES WILL LENOXX ELECTRONICS CORP. BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusions or limitations may not apply to you. [. . . ]