User manual LENOXX CD104

[. . . ] ® COMPACT DISC PLAYER AM/FM STEREO CASSETTE RECORDER MODEL CD-104 OPERATING INSTRUCTIONS PLAYS MUSIC COMPACT DISCS FULLY PROGRAMMABLE CD PLAYER WITH REPEAT RECEIVES AM/FM STEREO BROADCASTS RECORDS FROM CD, RADIO, OR BUILT-IN MICROPHONE FM STEREO AND POWER LED INDICATORS 2 WAY POWER - AC/DC REQUIRES 8 SIZE C BATTERIES (not included) PLEASE READ CAREFULLY BEFORE USE IB-CD104(TA)-FD-E-043002 WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THE PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in SERVICE the literature accompanying the appliance. IMPORTANT SAFETY INSTRUCTIONS 1. Do not block any ventilation openings, install in accordance with the manufacturers instructions. [. . . ] Do not allow it to touch your skin, and discard the leaking batteries. Do not mix batteries (OLD and NEW or CARBON and ALKALINE, etc. ). The use of rechargeable batteries is not recommended for this set because their voltage and life is lower than standard batteries. Installation of batteries should be done by an adult only. 11. 12. 13. 16. SAVE THESE INSTRUCTIONS 3 IB-CD104(TA)-FD-E-043002 You can use the AC power or batteries as a power source. CHOOSING THE POWER SOURCES To a wall outlet BATTERY COMPARTMENT AC SOCKET NOTE: One blade of plug and outlet is wider. TIP If the plug of the AC power cord does not match your outlet, do not force it. The plugs are polarized and only fit one way into the wall outlet and back of the set. TIP Replace the batteries when the POWER lamp dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player and remember to check the Battery Safety Instructions on Page 3. 1. Connecting the AC power cord Insert one end of the supplied AC power cord (located in the battery compartment) into the socket located at the rear of the player, and the other end to the wall outlet. 2. Using the player on batteries Insert 8 size C batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect the AC power cord from the player. C C C C 4 IB-CD104(TA)-FD-E-043002 PLAYING A CD 1 2 4 Connect the supplied AC power cord or batteries (see page 4). 1 2 Slide the FUNCTION switch to CD position (power on), the POWER lamp will be on. POWER lamp Lift the right corner of the CD DOOR marked OPEN to open it and place the CD in the CD compartment. The label side of the CD should face upward. 3 4 Close the CD DOOR by pushing it down. The display will show the total tracks on that CD. Press the CD PLAY button, the track number and PLAY will show steady on, the player plays all the tracks once. Track number 5 IB-CD104(TA)-FD-E-043002 PLAYING CD TRACKS REPEATEDLY (REPEAT PLAY) You can play CD tracks over and over in normal or programmed play mode (see page 7). FUNCTION SWITCH REPEAT 1. Slide the FUNCTION switch to CD position. Select the track by pressing or , and then press 3. Press the CD REPEAT button. . To repeat a single track (song) Press Press the REPEAT button once Display shows: REP. flashing all the tracks (all songs) Press the REPEAT button twice programmed tracks During programmed play, press the REPEAT button twice To cancel Repeat Play Press the REPEAT button until REP. and REP. A go off in the display. 6 IB-CD104(TA)-FD-E-043002 SELECTING YOUR OWN MUSIC PLAYING ORDER (Programmed Play) You can make a program of up to 19 tracks in the order you want them to be played. NOTE: Programming is only done during stop mode. PROGRAM 1. Slide the FUNCTION switch to CD position. Press or to select the tracks you want to program in the order you want. You can program up to 19 if you tracks, and the display will show continue to program. [. . . ] Magnetic fields may reduce the tape sensitivity or even erase the recording. Do not store tape for any length of time in a hot, moist or dusty place. Cleaning the Tape Heads Wipe the heads, the pinch roller and the capstan with a cleaning swab slightly moistened with cleaning fluid or alcohol after every 10 hours of operation for optimum playback and recording quality. After cleaning, insert a tape when the areas cleaned are completely dry. Cleaning the Cabinet RECORD/PLAY BACK HEAD PINCH ROLLER ERASE HEAD Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzene. CAPSTAN COTTON SWAB NOTE: In order to see and clean the head, you may have to press PLAY first. 17 IB-CD104(TA)-FD-E-043002 TROUBLE SHOOTING Problem The power is not on. General Remedy Connect the AC power cord to a wall outlet securely. [. . . ]