User manual LENOXX CD107

[. . . ] Heat - The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Grounding or Polarization - Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. Power Cord Protection - Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenient receptacles, and the point where they exit from the appliance. [. . . ] Batteries should be replaced (depending on the product) when the display gets dim or if the Low Battery Indicator shows or if the sound gets distorted. Do not store this product in high temperature areas. Batteries that are stored in a freezer or refrigerator for the purpose of extending shelf life should be protected from condensation during storage and defrosting. Batteries should be stabilized at room temperature prior to use after cold storage. If this product does not operate normally, see TROUBLE SHOOTING in this instruction manual. If you cant resolve the problem, or if the product is damaged, refer to the LENOXX WARRANTY INFORMATION. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the appliance is subsequently used. If liquid leaks from the batteries, carefully wipe this liquid. Do not allow it to touch your skin, and discard the leaking batteries. Do not mix batteries (OLD and NEW or CARBON and ALKALINE, etc. ). The use of rechargeable batteries is not recommended for this set because their voltage and life is lower than standard batteries. Installation of batteries should be done by an adult only. 11. 12. 13. 16. SAVE THESE INSTRUCTIONS 3 IB-CD107(AD)-FD-E-V1 CHOOSING THE POWER SOURCES AC SOCKET You can use the AC power or batteries as a power source. To a wall outlet NOTE: One blade of plug and outlet is wider. Battery compartment TIP If the plug of the AC power cord does not match your outlet, do not force it. The plugs are polarized and only fits one way into the wall outlet and back of the set. 1. Connecting the AC power cord Insert one end of the supplied AC power cord (located in the battery compartment) into the socket located at the rear of the player, and the other end to the wall outlet. 2. Using the player on batteries Insert 6 size C batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect and remove the AC power cord from the player. Replace the batteries when the POWER lamp dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player and remember to check the Battery Safety Instructions on Page 3. upper upper lower $ " # ! Insert new batteries according to sequence as shown on FIG. [. . . ] Unplug the headphones when listening through speakers. appears in the display even when a CD is in place. Insert the CD with the label side up. Make sure that the CD compartment is closed. Take and leave open out the CD an hour tothe CD DOOR for about dry moisture Make sure the FUNCTION switch is at CD condensation. the CD, Clean damaged. or replace it if the CD is badly Place the player in a location free from vibration. [. . . ]