User manual LENOXX CD109

[. . . ] Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Only use attachments/accessories specified by the manufacturer. Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel. [. . . ] If this product does not operate normally, see TROUBLE SHOOTING in this instruction manual. If you cant resolve the problem, or if the product is damaged, refer to the LENOXX WARRANTY INFORMATION. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when the appliance is subsequently used. If liquid leaks from the batteries, carefully wipe this liquid. Do not allow it to touch your skin, and discard the leaking batteries. Do not mix batteries (OLD and NEW or CARBON and ALKALINE, etc. ). The use of rechargeable batteries is not recommended for this set because their voltage and life is lower than standard batteries. Installation of batteries should be done by an adult only. 11. 12. 13. 16. SAVE THESE INSTRUCTIONS 3 IB-CD109(AD)-WM-E-121302 CHOOSING THE POWER SOURCES You can use the AC power or batteries as a power source. To a wall outlet NOTE: One blade of the plug and outlet is wider. Battery compartment AC SOCKET Replace the batteries when the POWER lamp dims or when the player stops operating. Replace all the batteries with new ones. Before you replace the batteries, be sure to take out the CD from the player and remember to check the Battery Safety Instructions on Page 3. If the CD does not play on batteries, this means the batteries are almost used up. But the radio may continue to play on these weak batteries because it uses less power than the CD player. 1. Connecting the AC power cord Insert one end of the supplied AC power cord into the socket located at the rear of the player, and the other end to the wall outlet. 2. Using the player on batteries Insert 6 size C batteries (not supplied) into the battery compartment. To use the player on batteries, disconnect and remove the AC power cord from the player. Insert new batteries as shown. 4 IB-CD109(AD)-WM-E-121302 PLAYING A CD 2 1 4 Connect the supplied AC power cord or batteries (see page 4). 1 2 Slide the FUNCTION switch (at the right side of the set) to CD position, the POWER lamp will turn on. Lift the right corner of the CD DOOR to open it and place a CD in the CD compartment. The label side of the CD should face upward. POWER lamp 3 4 PLAY/PAUSE Close the CD DOOR by pushing it down. The display will show the total tracks of that CD. TRACK Press the CD PLAY button. The PLAY/ PROGRAM lamp will be steady on, the player will play all the tracks in order once. 5 Track PLAY/PROGRAM number lamp IB-CD109(AD)-WM-E-121302 USE THESE BUTTONS FOR ADDITIONAL OPERATIONS OPEN THE CD DOOR BY LIFTING HERE VOLUME CONTROL (at the left side of the set) FUNCTION SWITCH (at the right side of the set) PHONES JACK BACKWARD FORWARD PLAY/PAUSE TIP When CD play is paused, the track number will flash and no music will play. To resume play, press the PAUSE button again, the track number will stop flashing and music will play. STOP To Adjust the volume Stop playback Press or Adjust VOLUME control STOP PLAY/PAUSE The track number will flash during pause. [. . . ] Make sure that the CD compartment is closed. and leave Take out the CD an hour tothe CD DOOR open for about dry moisture Make sure the FUNCTION switch is at CD condensation. the CD, Clean damaged. or replace it if the CD is badly Place the player in a location free from vibration. It is normal since the radio uses less power than the CD player. [. . . ]