User manual LENOXX CD163

[. . . ] ® COMPACT DISC PLAYER AM/FM DUAL CASSETTE RECORDER WITH REMOTE CONTROL MODEL CD-163 OPERATING INSTRUCTIONS INCLUDES FULL FEATURE REMOTE CONTROL MULTI-COLORED FLUORESCENT DISPLAY PLAYS MUSIC COMPACT DISCS KARAOKE FUNCTION WITH DUAL MIC. JACKS FULLY PROGRAMMABLE CD PLAYER WITH REPEAT PLAY RECEIVES AM/FM STEREO BROADCASTS ROTARY BASS & TREBLE CONTROLS RECORDS FROM CD, TAPE OR RADIO 2 WAY POWER - AC/DC REQUIRES 8 SIZE D BATTERIES (NOT INCLUDED) PLEASE READ CAREFULLY BEFORE USE IB-CD163(TA)-FREDS-E-042602 WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THE PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED PERSONNEL. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in SERVICE the literature accompanying the appliance. IMPORTANT SAFETY INSTRUCTIONS 1. [. . . ] Set the FUNCTION switch to CD position, two dashes -- will show on the VFD display. Open the CD DOOR by pressing the right corner marked OPEN/CLOSE and place the CD in the CD compartment. The label side of the CD should face upward. The display will show the total number of tracks (songs) on that CD. The player will play all the songs (tracks) once in order. To change the sound effect, adjust the BASS and TREBLE knobs to your taste. S TA N D B Y TIP: WILL SHOW IN THE DISPLAY IF THERE IS NO DISC IN THE CD COMPARTMENT OR IF THE DISC IS UPSIDE DOWN. 7 IB-CD163(TA)-FREDS-E-042602 USE THESE BUTTONS FOR ADDITIONAL OPERATIONS VOLUME CONTROL TIP When CD play is paused, will flash and no music will play. FUNCTION SWITCH To To resume play, press the PAUSE button again, will stop flashing and music will play. If you bump the set or the table it is sitting on, during CD play, the music will stop or skip for a few seconds. Adjust the volume Stop playback Press or Adjust VOLUME control STOP PLAY/PAUSE TIP Pause playback will flash during pause. Press again to resume play after pause. Go to the next track Go back to the previous track FORWARDS BACKWARDS or Press and hold down while playing until you find the point. Press the right corner of the CD DOOR marked OPEN/ CLOSE (press STOP first). Press the POWER switch, the display will go off and the STANDBY lamp will turn on. TIP This set has an electronic volume control, you may raise or lower the volume by pressing the VOLUME control ( or ). Locate a point in a song Remove the CD Turn off the power 8 IB-CD163(TA)-FREDS-E-042602 REPEAT PLAY PLAYING CD SONGS (TRACKS) OVER AND OVER You can play CD tracks over and over in normal or programmed play modes (see page 10). Adjust for the clearest sound. This indicator will light up when receiving FM Stereo broadcasts. T E LE RB BS AS You may adjust the BASS and TREBLE controls to change the tone of the set to your taste. 11 IB-CD163(TA)-FREDS-E-042602 USE THESE BUTTONS FOR ADDITIONAL OPERATIONS FM MODE FUNCTION VOLUME TIP · If the FM broadcast is To Adjust the volume Turn off the Radio Press or Set VOLUME control ( ). or noisy, set the FM MODE switch from STEREO to MONO. set has an electronic volume control, you may raise or lower the volume by pressing the VOLUME or ). control ( · This Set the FUNCTION switch to TAPE position or press the POWER switch. To improve broadcast reception Change position of the antenna for FM or FM Stereo. Move the set itself for AM. 12 IB-CD163(TA)-FREDS-E-042602 PLAYING A TAPE 1 2 4 3 Connect the supplied AC power cord or batteries (see page 4). 1 2 3 PO W ER STAN DB Y Press the POWER switch, the STANDBY lamp will go off and the VFD display will turn on. F U LL REEL A EM PTY REEL Set the FUNCTION switch to TAPE position. STOP/EJECT Press the STOP/EJECT button (DECK A or DECK B) to open the tape compartment and insert a recorded tape. The player turns on and starts playing. IN S E R T T H IS W AY 4 PLAY 13 IB-CD163(TA)-FREDS-E-042602 A 5 AUTO STOP When the set finishes playing one side of the tape, the set will stop. To hear the other side of the tape, flip the tape over, then insert and press PLAY. RELAY PLAY 1 2 Connect the supplied AC power cord or batteries (see page 4). To play tapes in DECK A and then DECK B, follow the steps below: 5 3 4 1 2 3 PO W ER Press the POWER switch, the STANDBY lamp will go off and the VFD display will turn on. STAN DB Y Set the FUNCTION switch to TAPE position. Press the cassette PLAY button on DECK A, DECK A will play. PLAY 4 PAUSE Press the cassette PAUSE button on DECK B. 5 PLAY Press the cassette PLAY button on DECK B. When DECK A finishes playing, DECK B will start playing automatically. When the tape finishes playing on DECK B, the set will stop. 14 6 IB-CD163(TA)-FREDS-E-042602 USE THESE BUTTONS FOR CASSETTE TAPE OPERATIONS ADDITIONAL VOLUME CONTROL PLAY RECORD PAUSE PLAY STOP/EJECT PAUSE REWIND & FAST F. STOP/EJECT REWIND & FAST F. To Adjust the volume Stop playback Fast forward or rewind the tape Pause playback Press or Adjust Press the VOLUME control ( or ). STOP/EJECT button FAST FORWARD REWIND button button or PAUSE button Press again to resume play after pause. [. . . ] The RECORD button does not function/The tape does not play. The sound is weak/The sound quality is poor. Cassette PLAY button pops up. Make sure the safety tab on the cassette is in place (see page 21). Make sure the FUNCTION switch is at TAPE position. [. . . ]