User manual LENOXX CDR190

[. . . ] Heat - The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. Power Sources - The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. Grounding or Polarization - Precautions should be taken so that the grounding or polarization means of an appliance is not defeated. Power Cord Protection - Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenient receptacles, and the point where they exit from the appliance. [. . . ] Slide the Function Switch to CD position, and the Mode Switch to ON position. To repeat a single track (song) all the tracks (all songs) Press (during play) Press the Prog/Repeat Button once Press the Prog/Repeat Button twice or . You may select the individual track to repeat by pressing To cancel Repeat Play Press the Prog/Repeat Button until the Repeat Lamp is off. 5. Playing CD in programmed or random order 1. Programmed Play You can make a program of up to 16 tracks in the order you want them to be played. Slide the Function Switch to CD position, and Mode Switch to ON. The letters P1 will show and the Play/Program Lamp will flash. Press or to select the tracks you want to program in the order you want. The letters P2 will show and the Play/Program Lamp will flash. You can program up to 16 tracks (Display will show P0 for program#10, and Pa, Pb . . . The Play/Program Lamp will remain flashing. Program/Repeat Random P L AY/ P R OG . P L AY / P RO G. To change the current program To cancel Program Play Just create a new program following the Programming procedure. Press the Stop Button and the Program Lamp goes off. Programmed memory will be lost When the Function Switch is moved to the OFF or RADIO position, or the CD door is opened. 2. Random Play Press the CD Random Button, and the display will show some moving symbols like . . . The set will play songs in random order. Press to skip to the next random song. To play the songs in random order To resume normal play Press the CD Random button again. 6. Listening to the radio AUTO LAMP VOLUME MODE SWITCH FUNCTION SWITCH BAND SWITCH TUNING CONTROL Connect the supplied AC power cord (see Setting the Clock). 1 2 3 4 5 Slide the Function Switch to RADIO, and the Mode Switch to ON position. Slide the Band Switch to the proper band position that you want. Tune into the station you prefer using the Tuning Control. Adjust for the clearest sound. Adjust the Volume Control for desired loudness. Slide the Function Switch to OFF position to turn off the Radio. Remember to switch the Mode Switch to ALARM or AUTO position after listening, and the Auto Lamp will turn on, so that the buzzer alarm or radio music will wake you up at your preset time. Make sure the volume control is adjusted loud enough to wake you up. 7. More about radio operation Phones Jack FM antenna Battery Compartment To improve broadcast reception Fully stretch out the FM antenna for FM reception. Reorient the player itself for AM reception. Or locate the set near a window. To listen without disturbing others Connect a headphone (optional - not included) into the Phones Jack at the back of the set. The speaker will automatically be silenced. [. . . ] has power. General sure the Function Switch Makeposition as you want. is at the right There is no sound. Adjust the volume. Unplug the headphones when listening through speakers. Make sure that the CD compartment is closed. appears in the display even when a CD is in place. CD player CD does not play. Place the CD with the label side up. [. . . ]