User manual LERVIA KH 1148 FAN HEATER

[. . . ] · Under no circumstances may the Fan Heater be submerged in fluids, or fluids be permitted to enter the appliance housing. Do not expose the appliance to humidity and do not use it outdoors. Should fluids nonetheless gain access into the appliance housing, immediately remove the plug from the wall socket and arrange for the appliance to be repaired by qualified specialists. · Under no circumstances may the Fan Heater be used in the vicinity of water, for example in a bath, shower, washbasin or in humid cellar rooms. The proximity of moisture presents a danger, even when the appliance is switched off. [. . . ] Explain to children the potential dangers of the device. · Lay the power cable in such a way that no one can tread on or trip over it. · Do not use extension cables. Correct use The Fan Heater serves the purpose of heating and ventilating living areas. This Fan Heater is intended exclusively for use in private households and may only be used for this purpose. To this belongs also the observance of all of the information in these operating instructions, especially the safety instructions. All other uses are deemed to be improper and may result in property damage or even in personal injury. Kompernaß GmbH accepts no liability for damage caused by improper use of the appliance. -5- KH1148_Heiz_IB_UK 10. 08. 2006 11:52 Uhr Seite 6 KH 1148 Delivery content Fan Heater Operating instructions Warranty card · Place the Fan Heater on a level surface. · Insert the plug into a wall socket. The Fan Heater is now ready for service. Device Overview Safety Carrying handle Switch for the oscillating function Function switch Control lamp Protective grating Safety switch Base Thermostat regulator Tilt cut-out This Fan Heater is fitted with a safety switch . Should the Fan Heater tip over, it switches itself off automatically. The Fan Heater first switches itself on again when it is in an upright position. Overheating protection The Fan Heater is fitted with overheating protection. In the event of overheating, it switches itself off. Should this happen, check to see if the protective grating is covered or blocked. Switch the Fan Heater to the position , , 0". Wait until it has cooled down before switching it back on. Technical data Mains voltage: Output: Heating level 1: Heating level 2: Protection class: 220-240V ~ 50Hz 1000 W 2000 W II Before the first use · Take the Fan Heater from the transport packaging. To avoid the chance of suffocations, ensure that they do not come into the possession of children. · Check the items to see that they are all present, complete and without any damage. Operation To use the ventilator function: · Place the function switch into the position Fan . · Place the thermostat regulator on HI. To use the heating function: · Place the function switch to the desired heating level, 1 or 2. -6- KH1148_Heiz_IB_UK 10. 08. 2006 11:52 Uhr Seite 7 KH 1148 The fan switches on and the control lamp lights up in red. The Fan Heater is fitted with switching levels: Position 0 Status of the Fan Heater OFF Fan, no heating 1 2 Warm air flow (1000 W) Hot air flow (2000 W) · After every use remove the plug from the wall socket. Room temperature setting · Place the function switch on the desired heating level, 1 or 2. [. . . ] Arrange for the Fan Heater to be checked by specialists. It is not possible to switch the Fan Heater off. The Fan Heater switches itself off. An electronic component is defective. Remove the plug from the wall socket and arrange for the Fan Heater to be checked over by specialists. The temperature programmed into the thermostat has been reached. [. . . ]