User manual LERVIA KH 1510 CHANGING TABLE HEATER

[. . . ] ⷠOnly use the appliance in dry rooms, never use it outdoors or in moist environments. ⷠCheck to ensure that the appliance is in a serviceable condition before taking it into use. The appliance may not be used if it shows signs of damage. ⷠEnsure that the power cable cannot come into contact with the hot protective grill. [. . . ] ⷠEnsure that your child does not become subject to additional warming effects, for example sunlight or heating. ⷠBe aware that even large children can soon perceive the warmth as unpleasant. This appliance is intended for use in areas in which immediate warmth may be required, e. This appliance is NOT intended for the heating of rooms, for use in vehicles, for industrial or commercial applications or for use outdoors. Use only the accessories and spare parts that are specified for this appliance. Other parts are possibly not sufficiently suitable or safe! Appliance: q Adjustment handle w Heater with protective grill e Control lamp r Pull switch t Wall bracket with screws/plugs Observe these details for your personal safety, and to avoid fire and fatal risks through electric shock: The heater may only be used when it is firmly fixed at the location of use. The heater may only be fixed horizontally onto a wall, not vertically and not on the ceiling. Do not assemble the heater below a wall power socket. 60 cm to the bath, measured from the edge of the bath ­ min. 120 cm from the shower, measured from the mid-point of the water exit location Power supply: Nominal power consumption: IP Protection type: Dimensions (L x W x H): Weight : Power cable length: Pull switch length: Swivel range: 220-240 V ~/ 50 Hz Fix the supplied wall bracket t with the three screws/washers and the plugs to the wall, as shown on the fold-out side. Slide the appliance from above onto the wall bracket t and press it completely down. Secure the appliance in that you screw the short screw through the wall bracket t from below and into the appliance. Check to ensure that the appliance is firmly fixed to the wall and cannot be dislodged by pulling on the pull switch r or in any other way. Conduct the power cable downwards and insert the power plug into a wall power socket. Use a dry cloth or, at the most, a lightly moistened one for cleaning the housing. Do not use solvents or abrasive cleaners on the plastic surfaces, they could be damaged by them. the heating rod and the reflector may not be cleaned. NEVER push your fingers through the protective grill. Do not dispose of the appliance in your normal domestic waste. [. . . ] Only in this way can a post-free despatch for your goods be assured. Before cleaning the appliance first switch it off and remove the power plug from the wall power socket. The warranty covers only claims for material and maufacturing defects, not for wearing parts or for damage to fragile components, e. The appliance is intended solely for private domestic use, not for commercial applications. [. . . ]