User manual LERVIA KH 4410 LAMINATOR

[. . . ] Package contents 1 Laminator Lervia KH 4410 10 80 micron laminating pouches DIN A4 for hot lamination 10 80 micron laminating pouches DIN A5 for hot lamination 10 80 micron laminating pouches for hot lamination of business cards 1 Operating instructions 1 Warranty card -4- KH4410_Laminator_UK 09. 06. 2006 9:23 Uhr Seite 5 Lervia KH 4410 5. Safety Instructions · Do not allow children handle electronic appliances unsupervised, as they may not always be able to assess the possible injury hazards. · Unplug the power cord after every use and before cleaning, so as to prevent the appliance from switching on inadvertently. · Check the appliance and all the parts for visible damages. [. . . ] Insert the power plug of the laminator into a power socket. Be sure to find a stabile location for the appliance. Switch on the appliance by flipping the ON / OFF switch . The red ON / OFF LED indicator light turns on. Set the selector switch for the pouch thickness and cold lamination to the desired pouch thickness (80 or 125 micron). The laminator now heats up to the operating temperature. As soon as the green LED indicator light "Ready" lights up, the laminator has reached its operating temperature. As soon as the operating temperature is reached, the green LED indicator light "Ready" will light up. For a more even laminating result, we recommend that you only begin the laminating process after waiting for an additional approx. 2-3 minutes, particularly when using thinner pouches (less than 125 micron), or when adjusting a different pouch thickness. Make certain that all corners of the document have at least two millimetres of space to the edge of the laminating pouch as shown in Fig. Make certain that you only use a single pouch for laminating. 1 For information about the lamination process, please read section 10. 2 Lay the document to be laminated into a laminating pouch of the appropriate size. -7- KH4410_Laminator_UK 09. 06. 2006 9:23 Uhr Seite 8 Lervia KH 4410 9. Preparing for cold lamination If you have previously performed hot lamination: Allow the laminator to cool completely after hot lamination before you begin the cold lamination. Otherwise the rolls inside the laminator are still hot. This can damage the laminating pouch and the document to be laminated!Insert the pouch guide into the holes on the back side of the laminator. Insert the power plug of the laminator into a power socket. Be sure to find a stabile location for the appliance. Switch on the appliance by flipping the ON / OFF switch . The red ON / OFF LED indicator light turns on. Set the selector switch for pouch thickness and cold lamination to "COLD". [. . . ] In case of doubt, consult your waste disposal facility. . . . slowly into the slot for manual pouch input . · 15. Warranty & service Let go of the sheet as soon as you notice that it is being pulled in automatically. The contaminants on the rollers inside the laminator are now transferred to the sheet of paper. [. . . ]