User manual LERVIA KH 9

[. . . ] · Under no circumstances should the oil radiator be used in the vicinity of water, for example in a bath, shower, washbasin or in humid cellar rooms. The proximity of moisture presents a danger, even when the appliance is switched off. · In event of operating malfunctions and before cleaning the appliance, remove the power plug from the wall socket. · Arrange for defective power plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. · This heating appliance has been filled with a specific volume of a special oil. [. . . ] Place a mounting bracket 8 under the heater element so that the parts with a screw thread project upwards. Lay a roller railer 9 over it, such that the screw threads protrude through the holes. Check to ensure that the recesses on the roller railers 9 face outwards. The screw ends projecting from the appliance must reach into the recesses. Screw one wing nut 0 onto each of the threaded ends of the mounting bracket 8 until it is hand tight. Proceed in the same manner with the other side. Turn the appliance over and place it on the rollers. Items supplied Oil Radiator 2 Roller rails 2 Mounting bracket 4 Wing nuts Operating instructions Technical data Rated voltage: Heat output: Thermostat: Heating gills: 220­240 V ~ 50 Hz 2300 - 2600 W Infinitely variable 9 -3- Commissioning 1. Unwind all of the power cable from the power cable retainer 7. 5. If you wish to switch the appliance off, first place the warm air switch 4 at the position OFF. Next, turn the heat level switch 2 to "0" and then the thermostat 3 to MIN. Remove the plug from the wall power socket. Note: Ensure that the thermostat 3 and the heat level switch 2 are standing at MIN resp. Insert the power plug into a wall power socket. Place the heat level switch 2 at "III" and the thermostat 3 at MAX. The control lamp "Power" 1 glows. Frost protection function You can programme this oil radiator so that, if the room temperature reaches 0°C, it switches itself on and begins to radiate heat automatically: 1. Insert the power plug into a wall socket. Position the heat level switch 2 at "I", "II" or "III", and the thermostat 3 at MIN. The oil radiator will now switch itself on if the temperature falls to 0°C. When the temperature rises above 0°C, the oil radiator switches itself off automatically. Important: With the heat level switch 2 you can regulate how quickly the appliance warms up. If you wish to heat it up particularly quickly, select heat level "III", if a slow warming up is preferred, select heat level "I". Using the thermostat 3 you can set it to the desired temperature. When the desired room temperature has been reached, slowly turn the thermostat 3 back until a quiet "click" is heard and the control lamp "Power" 1 extinguishes. The momentary room temperature will now be retained. [. . . ] In the event of misuse and improper handling, use of force and manipulations not carried out by our authorised service centre, the warranty will become void. Your statutory rights are not restricted in any way by this warranty. DES Ltd Units 14-15 Bilston Industrial Estate Oxford Street Bilston WV14 7EG Tel. : 0870/787-6177 Fax: 0870/787-6168 e-mail: support. uk@kompernass. com Irish Connection Harbour view Howth Co. Dublin Tel: 00353 (0) 87 99 62 077 Fax: 00353 18398056 e-mail: support. ie@kompernass. com Disposal Do not dispose of the apliance in your normal domestic waste. [. . . ]