User manual LEXIBOOK IG1000

[. . . ] Si vous-même ou votre enfant présentez les symptômes suivants : vertige, trouble de vision, contraction des yeux ou des muscles, perte de conscience, trouble de l'orientation, mouvement involontaire ou convulsion, veuillez immédiatement cesser de jouer et consulter un médecin. Thank you for your purchase of the Lexibook My first interactive DVD remote. Your new remote control is specially designed to play interactive DVDs. An interactive DVD offers interactive contents which can be directly run on a traditional DVD player and viewed on TV. [. . . ] 5, if no infra red signal is received during more than 30 seconds, the LED indicator will flash twice. You need to select the key to program again (redo step 1. If you execute the learning procedure between another DVD (or TV) remote and the interactive DVD remote, the previously learnt codes will be erased after having set the new codes successfully. 2, if the LED indicator immediately flashes twice when the and VOLUME DOWN keys are pressed, it indicates that the interactive remotes' batteries are low. If you notice that a learnt key only works occasionally, your old remote may contain dual signals. Execute the following steps to learn this command: 2. Press a key on the interactive DVD remote which you want to learn the command. The LED indicator will turn on and remain solid. take your old remote and face it to the interactive DVD remote. The transmitter (on the top side of the unit) of your old remote must be 4-8 cm close to the receiver of the interactive DVD remote (top side of the unit, near the PLAY key). Press and hold the corresponding key on your old remote for a few seconds. the LED indicator stops blinking and remains solid. If the LED indicator does not light up (or keeps blinking), adjust and align the two remotes again or redo step 1. If the command has been learnt successfully, the LED indicator will flash once and then turn off. You can release the key on your old remote. Press again the same key you pressed in step 2. The LED indicator will turn on and remain solid. On your old remote, press and keep holding the key you wish to program (same key as in step 2. 4) for a few seconds until the LED indicator flashes once. The dual signal command has then been learnt successfully. If you wish to end the learning mode, press the key which you pressed in step 1. The LED indicator will flash once and then turn off. [. . . ] You might use other keys, such as the number keys, to play the interactive games. when you enter a feature , instructions will be displayed onscreen. If an interactive DVD offers contents in several languages, you will be able to switch from one language to the other using the AUDIO key. To turn the TV on and off Exit function. [. . . ]