User manual LEXIBOOK SM2000

[. . . ] At the back, inside the battery compartment 5. Remote sensor description Refer to image D At the back, inside the battery compartment 1. Using a screwdriver, open the battery compartment located at the back of the remote sensor. Turn the water pump counter clockwise to unlock it, then pull it up. [. . . ] Use the and keys to select the desired outdoor channel between the 3 available channels ( , or icons). The selected channel must be the same as the one chosen for the remote sensor with the channel selector. If the channels are different, the main unit will no be able to receive the data sent by the sensor. Press the MODE/SET key to confirm your selection and go to the temperature display setting. note: · After a few seconds of inactivity, the unit will go back to normal mode. ⷠIf the sensor is exposed to very low temperatures for an extended period of time, the batteries may lose power which may cause the transmission range to be limited. high temperatures also reduce the battery performance. The channel function allows you to use up to 3 additional sensors. The main unit can identify each remote sensor thanks to their assigned channel (channel 1, 2 or 3). If you have one or two additional sensors, you can place them in a different location in your house; in a bedroom, for example. Your main unit can collect the temperature and humidity data of up to three remote sensors. Make sure you set each sensor to a different channel. Press and hold the key for 2 or 3 seconds to synchronize manually the remote sensors and the main unit. The weather station will detect automatically the new sensors. Note: it may take up to 1 minute before the main unit displays the readings. Use the and keys to toggle between °C or °F temperature display (indoor and outdoor). Press the MODE/SET key to confirm your selection and go to the clock setting. Note: After a few seconds of inactivity, the unit will go back to normal mode. In normal mode (idle screen), press the MODE/SET key six times to go to the RCC function mode. Press the MODE/SET key for about 2 seconds. When the reception is complete, the RCC icon will stop blinking and remain solid. note: · To use this function, the RCC selector must be set on the DCF or the MSF position. [. . . ] Barometric pressure historical graph The bar graph lets you see the pressure trend over the past 24 hours. The weather forecast, by the means of the animated icons, depends on the evolution of the barometric pressure. By consulting the barometric pressure historical graph you can evaluate the likeliness or the strength of the weather forecast currently displayed. Throughout the 28 days of the lunar month, the aspect of the moon changes. [. . . ]