User manual LEXICON CP-1 PLUS V 2.0 QUICK REFERENCE GUIDE

[. . . ] CP-1 Plus (Version 2. 0) Quick Reference Guide The Front Panel exicon DIGITAL AUDIO ENVIRONMENT PROCESSOR CP-1 Plus CP-1 I II SOURCE TAPE PRE POST INPUT LEVEL SYSTEM MUTE EFFECT MUTE POWER SOURCE MONITOR TAPE The Version 2. 0 Remote Control PANORAMA provides greater spaciousness and envelopment for either music or films. These programs can utilize left and right rear channels but are also effective using only two front loudspeakers. NORMAL PANORAMA 1 WIDE BANK 3 BANK switches between 12 factory Presets and 12 User registers where customized modes may be stored. PARAM selects the various adjustable parameters of the current mode. [. . . ] The MOVIE SURROUND modes work with film sound tracks to recreate the theater experience. MONO LOGIC expands the music and effects on monaural films. TV MATRIX provides surround effects for TV viewing of monaural, stereo and stereo-synthesized programs. PRO LOGIC should be used during playback of any encoded films or music. BALANCE: L and R adjust the left/right balance of all speakers: front, sides and rear. VOLUME: UP and DOWN adjust the level of all channels simultaneously. SYSTEM MUTE turns off all outputs and lights both SYSTEM and EFFECT MUTE LEDs. EFFECTS MUTE turns off any effects added by the CP-1. (Pushing EFFECT MUTE while in system- mute mode turns the effects alone back on. ) DOLBY SURROUND PRO - LOGIC SYSTEM EFFECT MUTE Note To store a modified Preset program, press PARAM until the display reads: MEMORIZE PROGRAM, then press any of the 12 program keys to store all current settings in the corresponding User register. User registers automatically store changes as they are entered. The CP-1's User Bank can be cleared and reloaded with duplicates of the factory Preset programs at any time. Turn on the CP-1 while holding down PARAM. Continue to hold down PARAM for several seconds. Push EFFECT MUTE to clear and reload the User Bank and to restore all initial settings of Volume, Balance, Contrast, Configuration, etc. Push PARAM again to begin normal operation. Lexicon CP-1 Plus (Version 2. 0) Digital Audio Environment Processor Manufactured under license from Dolby Laboratories Licensing Corporation. [. . . ] · Push PARAM UP or DOWN until the configuration you have chosen and the description in the display match. 1 2 3 Center Phantom Button IN Center Phantom Button IN 4 5 6 speaker connected to center output speakers connected to Main outputs Center Phantom Button IN speakers connected to Side outputs speakers connected to Rear outputs The actual angle, or "toe in" of the speakers should be set according to the manufacturer's suggestions. 7 8 9 Center Phantom Button IN 10 11 12 If you are using only one rear speaker, or a single amplifier channel for the rears, it may be hooked up to either the left or right rear output, as long as you use the correct Configuration number. Subwoofers are not shown in any of these configurations. Consult the subwoofer owner's manual or your dealer for proper placement of subwoofers. Choose the diagram that most closely corresponds to your room and note its number. 3 Oak Park Bedford, MA 01730 USA Lexicon Part # 070-09112 © 1992 Lexicon, Inc. [. . . ]