User manual LEXICON DC-1

[. . . ] Owner's Manual DC-1 Digital Controller Base & THX Versions Important Safety Instructions Save these instructions for later use. Follow all instructions and warnings marked on the unit. Always use with the correct line voltage. Refer to the manufacturer's operating instructions for power requirements. [. . . ] Turn the unit back ON and immediately press BYPASS. (Make sure you do not block the infrared receiver on the DC-1 front panel. ) The display will read: FACTORY PRESETS MENU EXIT RESTORE DEFAULTS Use MENU v or w to highlight RESTORE DEFAULTS, then press SELECT. This will clear and reload all preset effects and all factory settings of Volume, Balance, Contrast, Configuration, etc. When the message FACTORY DEFAULTS RESTORED is diplayed, press DONE to return to normal operation. Depending on the location of the DC-1 in your room, you may need to adjust the front panel Liquid Crystal Display (LCD) for optimum viewing. To adjust this display, press the MENU v, w or SELECT buttons on the Remote to enter the Main Menu. Press MENU w twice to select DISPLAY ADJUST. Press SELECT to highlight the Display Adjust Menu. Press MENU w to select FRONT PANEL DISPLAY. LCD Adjustment To adjust LCD contrast, use SELECT to highlight CONTRAST ADJUSTMENT, and MENU v or w to set the contrast of the display to its maximum as seen from your listening chair. Press DONE twice to return to the main menu. If you want to turn the front panel display off, use SELECT to highlight STATUS, then use MENU v or w to select OFF. Press DONE twice to return to the main menu. 17 Installation and Calibration The Video On-Screen Display Lexicon In addition to the front-panel LCD, the DC-1 contains a character generator for a video overlay display on television sets. Since the on-screen display is capable of showing the full menu of options available at any point, calibration of the system is faster and easier if the DC-1 video output is connected to a video input on a television monitor. Adjustments to the on-screen display are made from the Display Adjust menu. To display this menu, press the MENU v, w or SELECT buttons on the Remote to enter the Main Menu. Press MENU w twice to select DISPLAY ADJUST. Press SELECT to enter the Display Adjust menu. Press SELECT to open the On-Screen Display menu. This menu allows you to choose the position and duration of items displayed on-screen during normal operation, as well as the options of color or black and white display and conformance to local broadcast format. Adjusting the position allows you to move the DC-1 display items to a location where they will not interfere with any other video overlays your system may generate. The STATUS option allows you to choose to have the on-screen display always off, always on, or on for a two-second duration. Note that if you choose to have the display "time out", this will not affect the display of the main menu. Note also that parameter changes will still be performed when you make adjustments with MENU v or w, even if the display is inactive. If you choose ALWAYS OFF, you will not be able to use the video overlay, and even setup will have to be done using only the front-panel LCD. COLOR allows you to have the on-screen display presented in monochrome or color. [. . . ] If the DC-1 LCD displays normally at the end of this test, no problems have been found with the DC-1 circuitry. If the internal tests fail, the LCD may display an error message, or no message at all. If you find that your custom settings are routinely being corrupted, the lithium battery in the DC-1 may be faulty. This part is not fieldreplaceable -- contact Lexicon. [. . . ]