User manual LEXICON I-ONIX U42S

[. . . ] Owner's Manual IMPORTANT SAFETY INSTRUCTIONS WARNING FOR YOUR PROTECTION READ THE FOLLOWING: KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS THE APPARATUS SHALL NOT bE ExPOSED TO DRIPPING OR SPLASHING LIqUID AND NO ObjECT FILLED WITHI LIqUID, SUCH AS vASES, SHALL bE PLACED ON THE APPARATUS. DO NOT bLOCK ANY OF THE vENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS. DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOvES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT. [. . . ] One pair includes Mic/Line 3 and Mic/Line 4. 12. 48v LeD Lights when phantom power is active for the Mic/Line 3 and 4 input pair. Phantom power can be turned on for each combi-jack input pair via the 48V buttons on the back panel. Dynamic microphones do not require phantom power to operate, but are not harmed by it. Most condenser microphones do require phantom power to operate. If you are unsure about the phantom power requirements for your microphone, consult your microphone's documentation or contact the manufacturer. 4 13. MIc/LIne 4 GaIn KnOB Adjusts the input gain level for Mic/Line 4. 14. OutPut LeveL KnOB Controls the Left and Right Main output level. 15. S/PDIf LeD Lights when a S/PDIF connection is detected. Note that a connection to S/ PDIF can only be made when a USB connection is established. 16. MOnItOr MIx KnOB The I·ONIX U42S unit gives you the ability to hear your analog input signals directly and immediately while recording without having to adjust levels in software and before the delay caused by digital converters and computer recording latency. This zero-latency analog monitoring is controlled by the Monitor Mix knob, which you can use to adjust the blend between the live analog inputs (called "Direct") and any sounds coming back from the computer via USB ("Playback"). To hear only the live source input signals plugged into the U42S, turn the Mix knob fully left to Direct. To hear only the mix from the computer, turn the Mix knob fully right to Playback. The output from the Monitor Mix control is routed to the Main outputs and Headphone outputs. 17. uSB LeD Lights when a USB connection is detected. 5 rear and Side Panels 1 23 4 5 6 78 9 10 1. InStruMent 1 anD InStruMent 2 InPutS These unbalanced inputs accept 1/4" connectors and support instrument level sources (including guitars). Note that when the Instrument 1 input is connected, the Mic/Line input 1 is disabled. The same is true for the Instrument 2 and Mic/Line 2 inputs: when the Instrument is connected, the Mic/Line is disabled. 2. POwer JacK Use only the included PSS3-xxx power supply (where "xxx" indicates the appropriate mains voltage). 3. uSB POrt The USB Port is used to connect the U42S to your computer. The U42S is only compatible with USB 2. 0. 4. [. . . ] To mixdown your project, you will first need to set the left and right locators; one way to set the locators is to press [Ctrl] + [A] on your computer's keyboard and then press [P]. You can also click and drag either of the markers to the desired position. Once the locaters are set, go to File > Export > Audio mixdown. Click on the `Choose' button and name the file in the `File name:' field and select the location that you want the . wav file to be saved to in the `Look in' field and click the `Save' button. [. . . ]