User manual LEXICON LDI 12T

[. . . ] 12T System User Guide Unpacking and Inspection After unpacking the12T system modules, save all packing materials in case you ever need to ship the units. Thoroughly inspect the modules and packing materials for signs of damage. Report any damage to the carrier at once; report equipment malfunction to your dealer. Notice This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules, which are designated to provide reasonable protection against such interference in a residential installation. [. . . ] Click on the PARA button, to activate a display of three parameters. The parameter currently selected for editing is displayed with a border. If the parameter you want to edit is not visible in the display, click on the left or right part of the Page button to go to another parameter page. To return to Parameter mode, click on the Para. Set a value for the selected parameter with the Value dial. To make small adjustments, click on the dial, hold down the mouse button and move the pointer away from the dial before turning it. The further away from the dial the pointer is, the finer the value adjustments. Use the INC and DEC buttons for super fine manipulation of the active parameter. 34 34 Lexicon Studio T System User Guide Using the PC-90 Beyond the Basics Routing a Plug-In A Default routing is set in your Lexicon Studio system, to allow you to use your PC-90 as an auxiliary effect, monitoring the audio through the analog outputs on your audio interface as soon as it is Installed. This default routing configuration can be easily changed for your particular studio setup with the following procedure. 35 35 Using the PC-90 Lexicon The Reverb page on the Core-32 Control Panel allows you to route the two PC-90 DSP engines independently through any of the connectors of your audio interface. For each PC-90 engine, there are two input sources (left and right), and two output destinations (left and right). To assign a source to any of the input channels in your PC-90: 1. Clicking the left mouse button on the down-arrow of an input selector will open a menu displaying all sources available to route into your PC-90. Use the scrollbar to view the available sources. Click on a source to route it as an input source. The input selector will display your selection as the input source. NOTE: Input sources can only be be routed one at a time. To assign a destination to any of the output channels in your PC-90: 1. Click the left mouse button on the down-arrow of an output selector to open a menu of available destinations. Use the scrollbar to view the available destinations. Click on a source to route it as an output destination. The output selector will display your selection as the input source. 36 36 Lexicon Studio T System User Guide Using the PC-90 The diagram below is a flow chart of the audio routing from the previous picture of the control panel. Notice that PC-90 receives its input from Cubase VST via the VST_Aux_Send_1L and VST_Aux_Send_1R sources. [. . . ] Check the resources page for a resource conflict. Resources in your computer may have been depleted before the Core-32 card was installed. Try moving the board to another PCI slot or remove a card to make more resources available. A legacy device (a card with manually-set IRQs) may need to be disabled by removing the card. [. . . ]