User manual LEXICON MPX 200 REV 1

[. . . ] Important Safety Instructions Save these instructions for later use. · Always use with the correct line voltage. Refer to the manufacturer's operating instructions for power requirements. Be advised that different operating voltages may require the use of a different line cord and/or attachment plug. [. . . ] The compressor will always be available in any program, and is situated in front of any other effect for the Compressor "wet" component signal path. If compression is included in that program, the COMPRESSOR effect LED lights even though the compressor can always be turned on or off (using the Compressor button). Thus, the EFFECTS display shows what would run if that program were loaded. 2-1 SELECTING AND LOADING PROGRAMS The MPX 200 contains 240 presets and storage for 64 User Programs. To select a Preset or User Program as the running program: 1. (Omit this step if you are already in Program Load mode. ) Load Basic Operation CUEING PROGRAMS For live performance or mixing in the studio, you may want to "jump" from one program to another. The MPX 200 allows you to cue a program for loading. Turn the Adjust knob to the Program you want to load next (but do not press the Load button). After 4 seconds the display and the EFFECTS and ROUTING LEDs will revert to showing the currently running program, but the Load button will remain lit to indicate its armed status. To review the cued program, rotate the Adjust knob one click to redisplay its number and effects. Press Load to load your cued program. Load Lexicon, Inc. 1. Press the Edit button to enter the Editing mode. Each time you press the Edit button, it selects the next parameter for you to edit. MIDI Edit 2. Turn the Adjust knob to change the parameter. An appropriate value for that control will be displayed. After changing a parameter value, the MPX 200 will wait 4 seconds and then "timeout" and revert to displaying the active program number in the display. You can tell that Edit mode is still active because the current parameter LED is still lit. Compressor, Mix, and Tempo parameters can be set via System Parameters as either Global or Program. When set as Program, a change to these parameters is considered a "program edit" and is reported with the activation of the Edit LED. When set as Global, a change is not considered an "edit. " The Load button lights when a new program has been selected for loading, indicating that the button is armed. Pressing the Load button will then cause the selected program to load. (If the selected program has not been changed or the running program has not been edited since it was loaded, the LED will not be lit, indicating that pressing this button will have no effect. ) EDITING PROGRAMS The Adjust knob is used to control the EDIT functions. The lighted LED indicates the selected parameter while the display indicates the value of that parameter. [. . . ] Claims for shipping damages must be made with the carrier. Damage to any unit which has been altered or on which the serial number has been defaced, modified, or removed. will pay all labor and material expenses for covered items. Payment of shipping charges is discussed in the next section of this warranty. [. . . ]