User manual LEXMARK 2300 Install Guide

[. . . ] Changes are periodically made to the information herein; these changes will be incorporated in later editions. Improvements or changes in the products or the programs described may be made at any time. Lexmark may use or distribute any of the information you supply in any way it believes appropriate without incurring any obligation to you. You can purchase additional copies of publications related to this product by calling 1-800-553-9727. [. . . ] Before you create a destination, check the list at the bottom of the Web page. Make sure your recipient is not already listed. You can rapidly find your e-mail recipient by pressing # and entering the shortcut number on the OptraImage control panel. 9 If you want, assign a shortcut number (1- 245) to the This new destination is now available for Create a separate recipient entry for each destination and give them unique names easily identified in the destinations list. 1 Type the IP address of the OptraImage in the URL field of Your browser, and then press Enter. Before you create a destination, check the list at the bottom of the Web page. Make sure your recipient is not already listed. 8 If you want, assign a shortcut number (1- 245) to the You can rapidly find your FTP recipient by pressing # and entering the shortcut number on the OptraImage control panel. This new destination is now available for Make a test copy 3 Press Go/Send to send a copy to your printer. If Send/Fax is disabled, this option does NOT appear. Send a one page test fax to someone and ask for feedback. The scan unit parts may be contaminated with ink, toner particles or paper coatings. 1 Wet a clean, lint-free cloth or cotton swab with isopropyl Moving the swab from side to side. 3 Rotate the roller forward with your finger and repeat the Above cleaning procedures until the entire roller is cleaned. 1 Wet a clean, lint-free cotton cloth or swab with some 2 Open the ADF unit and document cover as shown. wipe The glass of flatbed and ADF area by moving the cloth or swab from side to side. Your scan unit is Moving the scan unit If you need to transport the scanner, follow these instructions to lock the scanner: 2 Raise the scanner high enough to push the switch down If you experience problems with papers double-feeding through the ADF, the pad assembly may be worn out and need to be replaced. 1 Turn off the scan unit and disconnect the power supply. 6 Reconnect the power supply and turn the scan unit back The following telecommunications notices apply to those machines in which the MarkNet print server is installed. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. The MarkNet print server has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules (Federal Communications Commission). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] If a charge for local calls is unacceptable, the "Dial" button should NOT be used for local calls. Only the 7-digits of the local number should be dialed from your telephone. No `111' or other calls can be made from this device during a main power failure. This modem must be used in conjunction with an approved surge protection device when connected to the PSTN network. [. . . ]