User manual LEXMARK 3200 MFP

[. . . ] English Edition: January 2003 The following paragraph does not apply to any country where such provisions are inconsistent with local law: LEXMARK INTERNATIONAL, INC. , PROVIDES THIS PUBLICATION "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Some states do not allow disclaimer of express or implied warranties in certain transactions; therefore, this statement may not apply to you. This publication could include technical inaccuracies or typographical errors. Changes are periodically made to the information herein; these changes will be incorporated in later editions. [. . . ] message disappears from the control panel. First time setup MFP panel: Please Set Date/Time Please Wait. . . Restart MFP panel: When initialization is completed, the Please Wait. . . The Please Set Date/Time prompt indicates that you need to set required fax information. Please Wait. . . Printer operator panel Printer panel: When you restart the MFP, a Please Wait. . . message appears on the second line of the control panel. When initialization is completed, the MFP control panel displays the current time and date, plus the Ready message. When you turn on your printer after installing the MFP, you may see the message on the left. The Analog Fax option is disabled unless there is a minimum 24MB of printer memory. If you receive this message, install additional printer memory to meet or exceed the 24MB requirement. 24MB of memory required for Fax. . . Hardware setup is now complete. You are ready to configure the MFP. Turn on the scanner and printer 28 Understanding the scanner indicator lights There are three indicator lights on top of the scanner. Each represents a different mode. Yellow Green Power indicator. Scanner is ready, but not in Power Saver mode. If green and red lights are off and yellow light is on, scanner is in Power Saver mode. Pressing a button removes the scanner from Power Saver mode. When the scanner is reactivated, there is a short warm-up period. When lit, an error is indicated and scanning is stopped. Check for possible paper jams or other paper feed errors. Refer to the user documentation on the CD. Red Indicator lights Turn on the scanner and printer 29 Step 8: Change your default copy settings A number of copy settings are available for customizing the MFP output to suit your needs. Some settings or values are displayed only if a specific option is installed on your printer. The indicator light next to the value on the control panel illuminates to indicate the current setting. When you select a new setting, the light changes to the selected setting to identify it as the current default. These settings remain active until new ones are selected or the factory defaults are restored. There are three methods to change the copy default settings for your MFP. They are 1) manually entering the information through the MFP control panel and operator panel, 2) using your browser to access the MFP IP address and then entering the Configure menu, or 3) using MarkVisionTM Professional to access the MFP IP address and enter the Configure menu. Manually changing settings Note: You can change the copy settings for individual jobs by changing settings on the control panel but not entering the Copy menu to save the settings. [. . . ] The Ringer Equivalence Number (REN) for this terminal equipment is located on the approved terminal equipment labeling. The REN assigned to each terminal equipment provides an indication of the maximum number of terminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed five. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local Telecommunications Company. [. . . ]