User manual LEXMARK C760

[. . . ] C760, C762 User's Guide June 2004 www. lexmark. com Lexmark and Lexmark with diamond design are trademarks of Lexmark International, Inc. , registered in the United States and/or other countries. 740 West New Circle Road Lexington, Kentucky 40550 Table of contents Chapter 1: Notices . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Edition notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Trademarks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Licensing notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] This setting has no effect on pages printed using the PCL XL or PostScript interpreters. If you try to print any data in the non-printable area defined by Normal Print Area, the printer will clip the image at the boundary defined by the Normal defined printable area. The printer does not print the last page of a print job until one of the following occurs: · The printer receives enough information to fill the page. · The printer receives a Form Feed command. · You select Print Buffer from the Job Menu. 1. . . 255 (90*) The printer prints the last page after the specified time. (Your printer may not support the entire range of values. ) Print Area Print Timeout To specify the amount of time (in seconds) the printer waits before printing the last page of a print job that does not end with a command to print the page. The print timeout counter does not start until Waiting is displayed. Disabled Printer Language To establish the default printer language used to communicate data from the computer to the printer. Note: Setting a printer language as the default does not prevent a software application from sending print jobs that use the other language. PCL Emulation PCL emulation, compatible with Hewlett-Packard printers. PS Emulation* PostScript emulation, compatible with Adobe PostScript language. Printer Usage To determine the behavior of the image transfer unit during printing. Max Speed Max Yield* The image transfer unit is engaged throughout the print job. The image transfer unit position is engaged based on page content. This may extend the life of certain print supplies. Printer retains downloaded resources only until memory is needed. It then deletes those resources associated with the inactive printer language. Printer retains all downloaded resources for all printer languages during language changes and printer resets. If the printer runs out of memory, 38 Memory Full is displayed. Resource Save To determine what the printer does with downloaded resources, such as fonts and macros stored in RAM, if the printer receives a job that requires more memory than is available. Off* On 70 Menu Item Purpose To specify how the printer responds when it is out of staples. Values Off Load Staples is displayed until someone loads staples. If an Auto Continue value is selected from the Setup Menu, the printer resumes printing after the specified timeout value. Printer stops printing, displays Load Staples, and sounds three quick beeps. Printer stops printing, displays Load Staples, and repeats three beeps every 10 seconds until the staple cartridge is replaced. An error message is displayed until someone replaces the toner cartridge. If an Auto Continue value is selected from the Setup Menu, the printer resumes printing after the specified timeout value. Printer stops printing, displays an error message, and sounds three quick beeps. [. . . ] Value Off Single Continuous Toner Alarm Lets you choose how the printer responds when toner is low. Off Single Continuous Result The alarm does not sound, but printing stops until the interventions are cleared. * The printer stops printing, displays a message, and activates the selected alarm type. The printer displays a message and continues printing. The printer stops printing, displays a message, and activates the selected alarm type. * If multiple attendance conditions are pending, the alarm only sounds when the first message is displayed. [. . . ]