User manual LEXMARK N5 WIRELESS ADAPTER GETTING STARTED (545 KB)

[. . . ] N5 Wireless Adapter Getting Started September 2002 www. lexmark. com Edition: September 2002 The following paragraph does not apply to any country where such provisions are inconsistent with local law: LEXMARK INTERNATIONAL, INC. , PROVIDES THIS PUBLICATION "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Some states do not allow disclaimer of express or implied warranties in certain transactions; therefore, this statement may not apply to you. This publication could include technical inaccuracies or typographical errors. Changes are periodically made to the information herein; these changes will be incorporated in later editions. [. . . ] The SSID is casesensitive, and there should be no extraneous spaces. · Click Back to return to the previous screen, and then reenter the data. For help, see page 38. My network is not listed on the Connect to the network (automatic) screen · Click Refresh. · Verify that all three lights on the printer adapter are on. · If you manually entered the SSID, verify the value LexmarkN5 was entered correctly. The SSID is casesensitive, and there should be no extraneous spaces. · Click Advanced to manually select the network settings. (Some ad hoc or closed system wireless networks may not automatically display the network settings. ) · Make sure the network is operating properly. For help, refer to your network documentation or contact your network administrator. Troubleshooting 26 I do not know the hexadecimal format of my WEP key · Go to another device on your network and note the selections for key and number of bits. · 40/64 bit keys contain five alphanumeric characters (0 through 9, A through F) and 128 bit keys contain ten. · If your network uses a passphrase, refer to the documentation that came with your access point. Setup was not successful (My printer was not found on the network) · Verify the network status of your computer's wireless adapter. If the network is not active, you did not reconnect to the network. Click Back to return to the previous screen. · Verify the IP address of the computer is valid. If the IP address was reset to 0. 0. 0. 0 when the computer was switched from an infrastructure network with DHCP to an Ad hoc network, you may need to reconfigure your computer's wireless adapter. For help, refer to the documentation that came with your computer's wireless adapter. · If the computer appears on the network, but the printer does not, go to Step 9: "Set up your printer adapter on the network" on page 6, and repeat the install process. · If you can see the LexmarkN5 network using the wireless search feature, it is likely the printer adapter never connected with your network. Go to Step 9: "Set up your printer adapter on the network" on page 6, and repeat the install process. 27 Troubleshooting The Lexmark printer software installation screen does not appear 1 2 3 My network printer does not appear in the list of available printers · Make sure the computer's wireless adapter network settings have been restored to their original values. Note: Refer to the values you wrote down in step 11 on page 8. · Unplug the printer adapter power supply, and then plug it in again. · Make sure all cables to the printer, printer adapter, electrical outlet, and network connection are secure (pages 4 through 5). [. . . ] For further explanation of your warranty alternatives and the nearest Lexmark authorized servicer in your area, contact Lexmark at (407) 563-4600, or on the World Wide Web at www. lexmark. com. Remote technical support is provided for this product throughout its warranty period. For products no longer covered by a Lexmark warranty, technical support may not be available or only be available for a fee. Extent of limited warranty We do not warrant uninterrupted or error-free operation of any product. [. . . ]