User manual LEXMARK OFFICEEDGE PRO 4000

[. . . ] 8 Understanding the parts of the printer. 18 Setting the security PIN of the printer. 47 Printing on both sides of the paper (duplexing). 133 Contents 5 Cleaning the exterior of the printer. [. . . ] note: Select Wireless connection when prompted to select a connection type. Installing the printer on other computers When the printer is set up on the wireless network, it can be accessed wirelessly by any other computer on the network. However, you will need to install the printer driver on every computer that will access it. You do not need to configure the printer again, although you will need to run the setup software on each computer to install the driver. If the installation dialog does not appear after a minute, then launch the CD manually: a Click , or click Start and then click Run. B In the Start Search or Run dialog, type D:\setup. Exe, where D is the letter of your CD or DVD drive. 3 Click Install, and then follow the instructions on the computer screen. If the installation dialog does not appear after a minute, then click the CD icon on the desktop. 5 Click Continue, and then follow the instructions on the computer screen. Determining the printer status using the network indicator light The Wi‑Fi or Ethernet indicator light shows the network status of the printer. Notes: • The network indicator light is located on the printer control panel. The printer may have an Ethernet or a wireless indicator light, or both, depending on your printer model. To find out if your printer has Ethernet or wireless capability, see the Quick Reference Guide, or contact your system support person. • The printer supports one local (USB) connection and one network connection (Ethernet or wireless) at a time. It is not possible to use both Ethernet and wireless at the same time. Networking 106 Indicator light Printer status Off • • • • The printer is turned off or is powering up. The printer is not connected to an Ethernet or a wireless network and is in Sleep mode. The printer has not been configured for an Ethernet or a wireless network. The printer is configured for an ad hoc connection, but it is not currently communicating with another ad hoc device. Blinking green • The printer has been configured for an Ethernet network, but it cannot establish a connection with the • The printer is out of the range of the access point (wireless router). € The printer is trying to communicate with the access point, but the access point is turned off or is not working properly. [. . . ] The replacement may be a new or repaired item. The replacement item assumes the remaining warranty period of the original product. Replacement is not available to you if the product you present for exchange is defaced, altered, in need of a repair not included in warranty service, damaged beyond repair, or if the product is not free of all legal obligations, restrictions, liens, and encumbrances. Before you present this product for warranty service, remove all print cartridges, programs, data, and removable storage media (unless directed otherwise by Lexmark). [. . . ]