User manual LG 1466LRS

[. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: t t t t Reorient or relocate the receiving antenna. increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Caution to the user: The Federal Communications Commission warns the users that changes or modifications of the unit not expressed approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ] To avoid any problems with stored data, keep all disks and magnetic tapes away from the monitor. Be sure the power to both the computer and monitor is switched off. The Vivitron 700 power switch is on the lower right corner on the front of the monitor. Connect the female end of the power cable to the power receptacle on the back panel of the monitor, and the other end to a grounded 120 or 240 VAC outlet. The power indicator on the front of the monitor lights. Here, you will want to experiment with the screen settings to choose the ideal image size and position for your needs. the monitor already has 7 preset modes for the most popular settings. Illustrated details on the screen controls can be found in the "Screen controls and functions" section of this manual. With the tilt-swivel, you can adjust your monitor to view the screen at any desired angle within 90 degrees horizontal and 20 degrees vertical. To turn the monitor both vertically and horizontally, hold it at its bottom with both hands, as shown below: Your Vivitron 700 monitor is equipped with a feature called On-Screen Display (OSD). OSD allows you to see the function adjustment you are currently using. If you are experiencing problems with your Vivitron 700 monitor, this troubleshooting section may help you to identify and solve any minor difficulties you may encounter. For any display concerns, insure that the monitor has warmed up for approximately 45 minutes before making a final judgment. If neither the power indicator nor the power saving indicators are lit, check first to see that the power cord is properly connected to both the back of the monitor and the wall outlet. Then, check to see that the monitor power switch is on. If the power saving indicator is lit: t Make sure that the computer is powered up. T Check to see if the monitor recovers from sleep mode when you press any key on the keyboard or move the mouse. T Make sure that the video signal cable is properly connected to the back of the system. T Make sure that the video signal cable is not damaged or cracked in any way. T Check the video connector system for any pins that might be bent or pushed in. T Make sure that the video card is properly seated in the slot of the system board. t Use the monitor's self-diagnosis function to check for any other problems. [. . . ] t Use the monitor's self-diagnosis function to check for any other problems. To use the self-diagnosis, power down the monitor, then press and hold the power switch until three color bars appear. During this time, you should see the power indicator light begin to blink (after about five seconds), then the screen should turn white, then a display of three colored bars appears in the middle of the display. If you observe these conditions, the monitor is working properly. [. . . ]