User manual LG 23185

[. . . ] It must not be used on people or animals. Never use your appliance to vacuum matches, glowing embers, or cigarette-ends. Avoid vacuuming hard, pointed objects, since they may damage the appliance or dust bag. [. . . ] If your vacuum cleaner has a fault, please contact your electrical retailer or an authorized service agent. If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required. PROTECTING THE ENVIRONMENT Once you have unpacked the unit, do not simply throw the packing into the household waste. Take them to the appropriate collecting points for recycling. 1 DJ68-00150B(0. 0) 4/23/02 4:44 PM Page 3 IDENTIFICATIONS OF PARTS HANDLE AIR REGULATOR SUCTION HOSE TOOL STORAGE COVER TUBE * CYCLONE FILTER * BUTTON FOR SUCTION HOSE REMOVAL CARRYING HANDLE FLOOR NOZZLE * RUG/FLOOR SELECTOR DUST-FULL INDICATOR CORD REWIND BUTTON POWER CONTROL SWITCH * ON/OFF BUTTON CLAMPER FOR DUST BAG COMPARTMENT Features marked with * may vary according to model. ASSEMBLING THE VACUUM - CLEANER READY FOR USE 1) Connect the suction hose to the suction tube. 2) Connect the suction tubes together (depending on model). 3) Connect the nozzle to the suction tube. 4) Connect the body connector to the body of the cleaner. OPTION: Adjusting the telescopic tube (depending on model). 2 DJ68-00150B(0. 0) 4/23/02 4:44 PM Page 4 *OPTION 1 *OPTION 2 EXTENDING : Holding narrow side of the telescopic tube with a hand, pull the hadle to the opposite side of it with another hand. SHORTENING : Push the handle to the narrow side of the tube, hoding it with another hand. POWER CORD 1) PULLING OUT The power cord is long enough to be drawn out for convenience. 2) REWINDING When you have finished cleaning, disconnect the plug from the electrical outlet and simply press the cord rewind button lightly with your toe. NOTE: When removing the power cord from the electrical outlet, grasp the plug, not the cord. POWER CONTROL (VARIABLE CONTROL TYPE ONLY) The vacuuming power can be adjusted to suit any situation with the electrical power control. MIN = For delicate fabrics, e. g. net curtains. Push and turn the Dust Barrel to the right. Adjust indicating marks each other carved on Dust Barrel and Cyclonic Filter. CYCLONIC FILTER CREVICE TOOL DUST BARREL REPLACING THE DUST BAG 1) To open the dust cover of the dust bag compartment, press the clamper upward. (The clamper is located at the front of the dust cover) 2) Remove the carrying bag from the cleaner. yy ;; yy ;; 5 DJ68-00150B(0. 0) 4/23/02 4:44 PM Page 7 3) After removing the used dust bag, insert the cardboard bag collar of the new dust bag into the carrying bag, and then insert it in its original position 4) Press the dust cover down gently until the clamper relocks. NOTE: Used dust bag can be sealed by removing the film from the paper and sticking the latter over the suction opening. (ONLY PAPER BAG) FOR CLOTH FILTER BAG After using, if the cloth filter bag is full of dust, clean the cloth filter bag and use it again. MAINTENANCE OR REPLACEMENT OF THE FILTERS 1) INLET-FILTER. · After detaching the filter, wash it lightly with water, dry it in the shade, and then insert it in its original position. · Open the dust cover, and then pull grille-filter forward. · Remove and replace the exhausted outlet-filter. · Push the grille filter, and then close the dust cover. [. . . ] · Remove and replace the exhausted outlet-filter. · Push the grille filter, and then close the dust cover. 6 yyy ;;; yy ;; yyy ;;; yy yyy ;; ;;; yy yyy ;; ;;; yyy ;;; DJ68-00150B(0. 0) 4/23/02 4:44 PM Page 8 USAGE OF FLOOR NOZZLE FOR RUG / FLOOR SELECTOR Before use make sure that the position of the selector is in the right position for the type of surface to be cleaned. Select the carpet indicator when cleaning carpets. [. . . ]