User manual LG 26LH1DC4

[. . . ] Installation and Operating Guide 26LH1DC3 26LH1DC4 26LH1DC5 Please read this manual carefully before operating your set. Record model number and serial number of the set. See the label attached on the back cover and quote this information to your dealer when you require service. www. lgcommercial. com WARNING / CAUTION NOTE TO CABLE TV INSTALLER This reminder is provided to call the CATV system installer's attention to Article 820-40 of the National Electric Code (U. S. A. ). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). [. . . ] Use the A D J D or E button to choose O n or O f f . When finished, press the O K ( E n t e r ) button. When finished, press M E N U repeatedly to remove the menus. Mode Standard Color Temperature Cool Screen Format 16:9 Noise Reduction Off G 2 3 4 Film Mode Off 11:20 PM Sep. 11, 2006 D E Move OK Select Menu Back Mode Color Temperature Screen Format Noise Reduction Film Mode Off On PICTURE CONTROL 11:20 PM Sep. 11, 2006 D E Select Menu Back Film Mode Options The user can watch movies with a more realistic picture on analog channels. Turn Film Mode On to view movies with optimum preset picture settings. 1 Press the M E N U button and then use the A D J D or E button to highlight the P i c t u r e menu and press the O K ( E n t e r ) button. Use the A D J D or E button to choose F i l m M o d e and press the O K ( E n t e r ) button. Use the A D J D or E button to choose O n or O f f . When finished, press the O K ( E n t e r ) button. When finished, press M E N U repeatedly to remove the menus. Mode Standard Color Temperature Cool Picture Screen Format 16:9 Noise Reduction Off Film Mode Off G 2 3 4 11:20 PM Sep. 11, 2006 D E Move OK Select Menu Back Mode Color Temperature Screen Format Noise Reduction Film Mode Off On 11:20 PM Sep. 11, 2006 D E Select Menu Back 51 COMMERCIAL MODE INSTALLER OVERVIEW Following is the Commercial Mode Operation Setup. Operating Installer Menu To set up the controls for the TV you will need to know how to enter the 26LH1DC3/4/5 Installer menu and make changes to the default values as required. If necessary, familiarize yourself with the 26LH1DC3/4/5 Installer menu and how to make and save changes in the menu. Optional Installer Remote You will need an Installer remote control similar to the one shown to the right. The TV's clonable features need to be set up before 2-5-5 + Menu is done. If the Master TV display panel's clonable features like: Clock Set, adding channel icons and channel labels, etc. are not done properly, then the cloned 26LH1DC3/4/5 TVs will all have problems. For example, do not do 2-5-5 + Menu more than once or the TV setup will become corrupted. If you need to start the procedure over, then begin by setting installer item 1 to 001, and pressing Enter to reset the TV to default values in the 17 installer menu. You can do 2-5-4 + Menu mode more than once but this mode is limited to only editing channel icons and channel labels. Refer to the appropriate section in the Manual for other TV features: Picture, Sound etc. *Note: Digital Font options are available only after a channel search has been run and when the TV is tuned to an active digital channel with digital captions. LODGING PTC INSTALLER MENU 000 INSTALLER SEQ 000 UPN 000-000-000-000 FPGA 09F1 PTC V1. 00. 000 CPU V1. 01. 00 Typical Installer Menu 52 COMMERCIAL MODE LT2002 Clone Programmer As the cloning procedure is being performed, specific steps need to be done at the indicated times to achieve the desired result. Be sure to do each cloning task as indicated. If a procedure or step is left out or not performed correctly, then the TV setup will be wrong and cloning may not work. At each step, pay attention to assure the TV screen shows the proper message(s) when cloning. If the message indicated does not appear, there is a problem with that step and cloning may not be successful. [. . . ] PHYSICAL CHANNEL NUMBER Actual digital major, dashed minor channel number that a station is broadcasting on. RGB (Red, Green, Blue) Connection input or output port available for producing a video image using three separate colors: Red, Green, and Blue. APPENDIX 2ND AUDIO PROGRAMMING/SAP Second Audio Programming (SAP) is another, separate audio channel available with some programming. Choosing SAP often refers to listening to audio in another language, such as Spanish or French. SIGNAL Picture and sound traveling through a cable, or over the air, to the TV. [. . . ]