User manual LG 26LX1R

[. . . ] This is normal, there is nothing wrong with TV. · Some dot defects may appear on the screen, like red, green or blue spots. However, this will have no adverse effect on the monitor's performance. · Avoid touching the LCD screen or holding your fingera(s) against it for long periods of time. [. . . ] · Stereo, SAP modes are available only if included on the broadcast signal. Press the ENTER button to save. 2 37 Operation T imer Menu Options Clock Setup TIMER Clock Off timer On timer Auto off TIMER Clock Off timer On timer Auto off G -- : -- AM Menu Prev. - If current time setting is wrong, reset the clock manually. 1 2 3 4 5 Press the MENU button and then use D / E button to select the TIMER menu. Press the Press the Press the G G G button and then use button and then use button and then use D /E D /E D /E button to select Clock. button to set the minutes. Press the EXIT button to return to normal TV viewing. On/Off Timer Setup TIMER Clock Off timer On timer Auto off TIMER Clock Off timer On timer Auto off G On Off 12 : 00 AM Volume 30 Ch. TV 2 Menu Prev. - TIMER function operates only if current time has been set. - Off timer function overrides On timer function if they are set both set to the same time. - The TV must be in standby mode for the On timer to work. - If you do not press any button within 2 hours after the TV turns on with the On timer function, the TV will automatically revert to standby mode. 1 2 3 4 5 6 7 Press the MENU button and then use D / E button to select the TIMER menu. Press the G button and then use D /E button to select Off timer or On timer. Press the G button and then use D / E button to select On. · To cancel On/Off timer function, select Off. Press the Press the G G button and then use button and then use D /E D /E button to set the hour. · GHOSTS: Ghosts are caused when the TV signal splits and follows two paths. One is the direct path and the other is reflected off tall buildings, hills or other objects. Changing the direction or position of the antenna may improve reception. · SNOW: If your receiver is located at the weak, fringe area of a TV signal, your picture may be marred by small dots. It may be necessary to install a special antenna to improve the picture. An old, bad, or illegally recorded tape is being played. Strong, random signals from a car or airplane interfere with the TV signal. The program wasn't captioned when it was produced, transmitted, or taped. Using Closed Captions Captions are the subtitles of the dialogue and narration of television programs. For prerecorded programs, program dialogue can be arranged into captions in advance. Its possible to caption a live program by using a process called real-time captioning, which creates captions instantly. Real-time captioning is normally done by professional reporters using a machine shorthand system and computer for translation into English. [. . . ] When pressing the button, the light is blinked at a time. Programming code numbers for the corresponding component can be found on the following pages. Again, if the code is correct, the device will turn off. Press the MENU button to store the code. [. . . ]