User manual LG 32LG5700

[. . . ] Number of pages : 32 N O T E S "This part contain Eco-hazardous substances (Pb, Cd, Hg, Cr6+, PBB, PBDE, etc. ) within LG standard level, Details should be followed Eco-SCM management standard[LG(56)-A-2524]. Especially, Part should be followed and controlled the following specification. (1)Eco-hazardous substances test report should be submitted when Part certification test and First Mass Production. (2) Especially, Don't use or contain lead(Pb) and cadmium(Cd) in ink. 3. Special Instructions * LGENT : Printed in China * LGENP : Printed in China * LGEIL : Printed in India * LGEDI : Printed in Indonesia * LGEIN : Printed in Indonesia * LGEMA : Printed in Poland * LGETH : Printed in Thailand * LGEWA : Printed in U. K. [. . . ] INPUT External input modes rotate in regular sequence: TV, AV1-2, Component 1-2, RGB-PC, HDMI1 and HDMI2. (AV 1-2, Component 1-2, RGB-PC, HDMI1, and HDMI2 input sources are linked automatically, only if a device is connected. ) Inside the Sliding Cover 1 4 7 2 5 8 0 PICTURE ADJUST SOUND SAP 3 6 9 BACK CC PICTURE Selects the factory preset picture depend on the viewing environment. SOUND Selects the factory preset sound for type of program. SAP Analog mode: Selects MTS sound (Mono, Stereo, or a SAP) DTV mode: Changes the audio language. CC Select a closed caption. ADJUST Adjust the screen resolution, position, size and phase. Installing Batteries Remote control effective range TV INPUT INPUT POWER TV INPUT INPUT POWER DVD MODE CABLE VCR STB TV TV AUDIO DVD MODE CABLE VCR STB I AUDIO Open the battery compartment cover on the back side and install the batteries matching correct polarity (+ with +, - with -). Don't mix old or used batteries with new ones. Close cover. BRIGHT BRIGHT MENU BRIGHT + MENU BRIGHT + I I Use a remote control up to 7 meters distance and 30 degree (left/right) within the receiving unit scope. Dispose of used batteries in a recycle bin to preserve environment. I I 11 MFL34797033-en-simple 1/20/04 12:34 AM Page 12 PREPARATION BACK COVER FOR WIRE ARRANGEMENT I Here shown may be somewhat different from your TV. Plasma TV Model 12 PREPARATION 1 Hold the CABLE MANAGEMENT with both hands and pull it backward as shown. CABLE MANAGEMENT 2 Connect the cables as necessary. To connect an additional equipment, see the EXTERNAL EQUIPMENT SETUP section. 3 Install the CABLE MANAGEMENT as shown. MFL34797033-en-simple 1/20/04 12:34 AM Page 13 LCD TV Model PREPARATION 1 Connect the cables as necessary. To connect an additional equipment, see the EXTERNAL EQUIPMENT SETUP section. 2 Install the CABLE MANAGEMENT as shown. CABLE MANAGEMENT 3 Bundle the cables using the supplied TWISTER HOLDER. (This feature is not available for all models. ) !How to connect COMPONENT IN 1 Connect the video outputs (Y, PB, PR) of the digital set top box to the C O M P O N E N T I N V I D E O 1 jacks on the set. Match the jack colors (Y = green, PB = blue, and PR = red). Connect the audio output of the digital set-top box to the C O M P O N E N T I N A U D I O 1 jacks on the set. R (CONT 2 1 /DVI IN VIDEO AUDIO S- ( ) 2 1 2 2. How to use I Turn on the digital set-top box. (Refer to the owner's manual for the digital set-top box. operation) Select C o m p o n e n t 1 input source by using the I N P U T button on the remote control. If connected to C O M P O N E N T I N 2 input, select C o m p o n e n t 2 input source. Component 1/2 Yes Yes Yes Yes Yes HDMI1/DVI, HDMI2 No Yes Yes Yes Yes 1280x720p 1920x1080i Y, CB/PB, CR/PR Resolution 720x480i 720x480p Horizontal Frequency(KHz) 15. 73 15. 73 31. 47 31. 50 44. 96 45. 00 33. 72 33. 75 26. 97 27 . 00 33. 71 33. 75 67 . 432 67 . 50 Vertical Frequency(Hz) 59. 94 60. 00 59. 94 60. 00 59. 94 60. 00 ( 59. 94 60. 00 ) Y PB PR L R I I Signal 480i 480p 720p 1080i 1080p 1920x1080p 23. 976 24. 00 29. 97 30. 00 59. 94 60. 00 17 MFL34797033-en-simple 1/20/04 12:34 AM Page 18 EXTERNAL EQUIPMENT SETUP DVD SETUP When connecting Component cable 1. How to connect 1 EXTERNAL EQUIPMENT SETUP Connect the video outputs (Y, PB, PR) of the DVD to the C O M P O N E N T I N V I D E O 1 jacks on the set. Match the jack colors (Y = green, PB = blue, and PR = red). Connect the audio outputs of the DVD to the C O M P O N E N T I N A U D I O 1 jacks on the set. I/DVI IN COMPONENT IN 2 R (CONT 1 VIDEO AUDIO S- ( ) 2 2. [. . . ] Ensure you are pointing the remote control directly at the TV. I Ensure that the batteries are installed with correct polarity (+ to +, - to -). I Ensure that the correct remote operating mode is set: TV, VCR etc. I No broadcast on station tuned with Auto off activated. I I Power is suddenly turned off 26 APPENDIX The video function does not work. [. . . ]