User manual LG 32LS3450

[. . . ] Stock (Paper) • Cover : Coated paper , Snow White 150 g/㎡ • Inside : Uncoated paper , 백상지 60 g/㎡ 4. ) within LG standard level, Details should be followed Eco-SCM management standard[LG(56)-A-2524]. Especially, Especially Part should be followed and controlled the following specification. Specification (1) Eco-hazardous substances test report should be submitted when Part certification test and First Mass Production. [. . . ] Use an extension cable that supports USB 2. 0 if the USB cable or USB memory stick does not fit into your TV’s USB port. A-6) Owner’s manual Polishing cloth (Depending on model) Use this to remove dust from the cabinet. A-5) ASSEMBLING AND PREPARING 13 NOTE y y Antenna Isolator Installation Guide - - Use this to install TV in a place where there is a voltage difference between TV Set and GND of antenna signal. » » If there is a voltage difference between TV Set and GND of antenna signal, the antenna contact might be heated and excessive heat might cause an accident. - - You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. It is recommended to mount the isolator to the wall. If it cannot be mounted to the wall, mount it on the TV. Avoid disconnecting the antenna Isolator after installation. - - Before starting, be sure that the TV antenna is connected. Connect one end of the isolator to cable/antenna jack and the other to TV set or set-top box. €Equipment connected to the protective earthing of the building installation through the mains connection or through other equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some circumstances create a fire hazard. Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below a certain frequency range (galvanic isolator, see EN 60728-11)” When applying the RF Isolator, a slight loss of signal sensitivity can occur.  14 ASSEMBLING AND PREPARING CAUTION y y Power Cord Installation Guide - - If the power cord provided with TV looks like the below picture, please ensure that it is inserted in the right direction. ENGLISH ENG TV Power Cord Correct Wrong ASSEMBLING AND PREPARING 15 Parts and buttons ENGLISH ENG A type : 19/22/26/32LS35**, 26/32/42CS46**, 32/42LS340* B type : 32/42LS345* Screen Screen buttons Remote control and intelligent sensors1 Power indicator Speakers OK OK Speakers Remote control and intelligent sensors1 SETTINGS INPUT Touch buttons SETTINGS INPUT OK SETTINGS INPUT Power indicator A type2 H H Buttons B type Adjusts the volume level. Accesses the main menu, or saves your input and exits the menus. 1 Intelligent sensor - Adjusts the image quality and brightness based on the surrounding environment. 2 A type buttons are touch sensitive and can be operated through simple touch with your finger. 16 ASSEMBLING AND PREPARING Lifting and moving the TV When moving or lifting the TV, read the following to prevent the TV from being scratched or damaged and for safe transportation regardless of its type and size. Y y When transporting a large TV, there should be at least 2 people. Y y When transporting the TV by hand, hold the TV as shown in the following illustration. ENGLISH ENG CAUTION y y Avoid touching the screen at all times, as this may result in damage to the screen. [. . . ] English View the encrypted (pay) services in digital TV mode. This feature is not available in all countries. NOTE yy Check if the CI module is inserted into the PCMCIA card slot in the right direction. If the module is not inserted properly, this can cause damage to the TV and the PCMCIA card slot. [. . . ]