User manual LG 47LA690V

[. . . ] OWNER’S MANUAL LED TV LA62** LA64** LA66** LA69** LA74** LN57** * LG LED TV applies LCD screen with LED backlights. Please read this manual carefully before operating your set and retain it for future reference. P/NO : MFL67658608 (1303-REV01) Printed in Korea www. lg. com 2 TABLE OF CONTENTS TABLE OF CONTENTS 3 3 4 10 37 38 Using the User guide MAINTENANCE Cleaning your TV - Screen, frame, cabinet and stand - Power cord ENGLISH ENG Licenses OPEN SOURCE SOFTWARE NOTICE Safety Instructions - Viewing 3D Imaging (Only 3D models) 38 38 38 38 39 TROUBLESHOOTING EXTERNAL CONTROL DEVICE SETUP SPECIFICATIONS 12 12 12 15 16 17 18 18 21 23 25 Installation Procedure ASSEMBLING AND PREPARING Unpacking Separate purchase Parts and buttons Lifting and moving the TV Setting up the TV - Attaching the stand Mounting on a table Mounting on a wall Tidying cables 39 26 26 26 27 28 28 29 29 30 30 30 31 31 32 MAKING CONNECTIONS Antenna connection Satellite dish connection HDMI connection DVI to HDMI connection Component connection Composite connection MHL connection Audio connection - Digital optical audio connection USB connection CI module connection Headphone connection Euro Scart connection WARNING yy If you ignore the warning message, you may be seriously injured or there is a possibility of accident or death. 33 35 36 36 36 REMOTE CONTROL Magic Remote Control Functions Registering Magic Remote Control How to use Magic Remote Control Precautions to Take when Using the Magic Remote Control CAUTION yy If you ignore the caution message, you may be slightly injured or the product may be damaged. NOTE yy The note helps you understand and use the product safely. Please read the note carefully before using the product. LICENSES / OPEN SOURCE SOFTWARE NOTICE 3 Licenses Supported licenses may differ by model. For more information about licenses, visit www. lg. com. Manufactured under license from Dolby Laboratories. [. . . ] yy When transporting the TV by hand, hold the TV as shown in the following illustration. ENGLISH ENG CAUTION yy Avoid touching the screen at all times, as this may result in damage to the screen. yy It is recommended to move the TV in the box or packing material that the TV originally came in. yy Before moving or lifting the TV, disconnect the power cord and all cables. yy When holding the TV, the screen should face away from you to avoid damage. yy When transporting the TV, do not expose the TV to jolts or excessive vibration. yy When transporting the TV, keep the TV upright, never turn the TV on its side or tilt towards the left or right. yy Do not apply excessive pressure to cause flexing /bending of frame chassis as it may damage screen. yy Hold the top and bottom of the TV frame firmly. Make sure not to hold the transparent part, speaker, or speaker grill area. 18 ASSEMBLING AND PREPARING Setting up the TV Image shown may differ from your TV. ENGLISH ENG Attaching the stand LA62**, LA64**, LA66**, LN57**-ZE/ZK 1 4 EA M4 x 14 3 (Only LA62**, LN57**-ZE/ZK) Stand Body Front Stand Base M4 x 14 4 EA 2 (Only LA62**, LN57**-ZE/ZK) (Only LA64**, LA66**) (Only LA64**, LA66**) M4 x 14 4 EA ASSEMBLING AND PREPARING 19 LA69**, LA74** 3 ENGLISH ENG 1 Stand Base M4 x 20 4EA 2 20 ASSEMBLING AND PREPARING LN57**-ZA 1 Stand Body 3EA P5 x 25 CAUTION yy When attaching the stand to the TV set, place the screen facing down on a cushioned table or flat surface to protect the screen from scratches. yy Make sure that the screws are inserted correctly and fastened securely. (If they are not fastened securely enough, the TV may tilt forward after being installed. ) Do not use too much force and over tighten the screws; otherwise screw may be damaged and not tighten correctly. ENGLISH ENG Stand Base 2 NOTE yy Removing the protective film (from the bottom) (Depending on model) Protective film is temporarily attached to prevent the surface of the product from being damaged during delivery. Once the TV has been installed, please remove the protective film on the bottom of the unit as shown in the figure. 3 yy Remove the stand before installing the TV on a wall mount by performing the stand attachment in reverse. 4EA M4 x 14 ASSEMBLING AND PREPARING 21 Mounting on a table 1 Lift and tilt the TV into its upright position on a table. --  eave a 10 cm (minimum) space from the L wall for proper ventilation. Securing the TV to a table Fix the TV to a table to prevent from tilting forward, damage, and potential injury. To secure the TV to a table, insert and tighten the supplied screw on the rear of the stand. (Only 32/39/42/47/50/60LN57**-ZA) ENGLISH ENG 10 cm 10 cm m 10 c 10 cm 10 cm (Only 32/39/42/47/50LN57**-ZE/ZK, 32/39/42/47/50LA62**, 32/42/47/50LA64**, 32/42/47/50LA66**) 2 Connect the power cord to a wall outlet. CAUTION yy Do not place the TV near or on sources of heat, as this may result in fire or other damage.  Using the Kensington security system (This feature is not available for all models. ) Image shown may differ from your TV. yy The Kensington security system connector is located at the rear of the TV. For more information of installation and using, refer to the manual provided with the Kensington security system or visit http://www. kensington. com. Connect the Kensington security system cable between the TV and a table. 2 EA, P4 x 8 (Only 47/50LN57**-ZE/ZK, 47/50LA62**, 47/50LA64**, 47/50LA66**) 2 EA, M4 x 8 (Only 32/39/42LN57**-ZE/ZK, 32/39/42LA62**, 32/42LA64**, 32/42LA66**) 22 ASSEMBLING AND PREPARING NOTE (Only 32/39/42/47/50LN57**-ZE/ZK, 32/39/42/47/50LA62**, 32/42/47/50LA64**, 32/42/47/50LA66**) How to fix the TV to a table 1. Connect the Desk-mount Cables to the Stand Base using the Bracket Screws. 2. Fix the Desk-mount Cables to a table using the Desk-mount Screws. 3. Once the TV is fixed, move the table close to the wall. Children may go in, causing injuries. Adjusting the angle of the TV to suit view (This feature is not available for all models. ) Swivel 15 degrees to the left or right and adjust the angle of the TV to suit your view. (Only LA62**, LA64**, LA66**, LN57**-ZE/ZK) ENGLISH ENG 15 15 WARNING yy To prevent TV from falling over, the TV should be securely attached to the floor/ wall per installation instructions. [. . . ] yy To remove major dirt, wipe the surface with a soft cloth dampened in clean water or a diluted mild detergent. Then wipe immediately with a dry cloth. CAUTION yy Avoid touching the screen at all times, as this may result in damage to the screen. yy Do not push, rub, or hit the screen surface with your fingernail or a sharp object, as this may result in scratches and image distortions. yy Do not use any chemicals as this may damage the product. [. . . ]