User manual LG 50PG20C-UA

[. . . ] Model Description MODEL SUFFIX PG10/20/30-UA Park SY 08. 01. 21 KANG KWANG SUK 08. 01. 21 BRAND Product Name LG Part No. PG10/20/30 MFL34797073 (0804-REV02) USA 2. Printing Specification 1. Printing Colors · Cover : 1 COLOR (BLACK) · Inside : 1 COLOR (BLACK) 3. Stock (Paper) · Cover : Coated paper , S/White 150 g/ · Inside : Uncoated paper , 60 g/ 4. [. . . ] LG is not liable for these kinds of accidents. LG is not liable for TV damage or personal injury when a non-VESA or non specified wall mount is used or the consumer fails to follow the TV installation instructions. CAUTION G Do not install your wall mount kit while your TV is turned on. It may result in personal injury due to electric shock. MFL34797073-en-simple 2 4/16/08 6:48 PM Page 15 SECURING THE TV TO THE WALL TO PREVENT FALLING I I You should purchase necessary components to prevent TV from falling off of the stand. We recommend that you set up the TV close to a wall so it cannot fall over if pushed backwards. Additionally, we recommend that the TV be attached to a wall so it cannot be pulled in a forward direction, potentially causing injury or damaging the product. Caution: Please make sure that children don't climb on or hang from the TV. PREPARATION I Insert the eye-bolts (or TV brackets and bolts) to tighten the product to the wall as shown in the picture. * If your product has the bolts in the eye-bolts position before inserting the eye-bolts, loosen the bolts. * Insert the eye-bolts or TV brackets/bolts and tighten them securely in the upper holes. Secure the wall brackets with the bolts (not provided as parts of the product, must purchase separately) to the wall. Match the height of the bracket that is mounted on the wall to the holes in the product. Ensure the eye-bolts or brackets are tightened securely. I Use a sturdy rope (not provided as parts of the product, must purchase separately) to tie the product. It is safer to tie the rope so it becomes horizontal between the wall and the product. !NOTE G G Use a platform or cabinet strong enough and large enough to support the size and weight of the TV. To use the TV safely, make sure that the height of the bracket on the wall and the one on the TV are the same. 15 MFL34797073-en-simple 2 4/16/08 6:48 PM Page 16 PREPARATION I To prevent damage do not connect to the power outlet until all connections are made between the devices. ANTENNA OR CABLE CONNECTION 1. Antenna (Analog or Digital) Wall Antenna Socket or Outdoor Antenna without a Cable Box Connection. For optimum picture quality, adjust antenna direction if needed. R Wall Antenna Socket Multi-family Dwellings/Apartments (Connect to wall antenna socket) ANTENNA/ CABLE IN Outdoor Antenna (VHF, UHF) RF Coaxial Wire (75 ohm) Single-family Dwellings /Houses (Connect to wall jack for outdoor antenna) ( ) Copper Wire ( ) Be careful not to bend the copper wire when connecting the antenna. 2. Cable Cable TV Wall Jack RF Coaxial Wire (75 ohm) ANTENNA/ CABLE IN To improve the picture quality in a poor signal area, please purchase a signal amplifier and install properly. I If the antenna needs to be split for two TV's, install a 2-Way Signal Splitter. I If the antenna is not installed properly, contact your dealer for assistance. I ( ) 16 R R PREPARATION MFL34797073-en-simple 2 4/16/08 6:48 PM Page 17 EXTERNAL EQUIPMENT SETUP I To prevent the equipment damage, never plug in any power cords until you have finished connecting all equipment. HD RECEIVER SETUP This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. Component Connection 1. How to connect 1 Connect the video outputs (Y, PB, PR) of the digital settop box to the C O M P O N E N T I N V I D E O 1 jacks on the TV. Match the jack colors (Y = green, PB = blue, and ( PR = red). [. . . ] I Is the power cord inserted into wall power outlet?I Check your antenna direction and/or location. I Test the wall power outlet, plug another product's power cord into the outlet where the product's power cord was plugged in. I I I No picture &No sound Picture appears slowly after switching on This is normal, the image is muted during the product startup process. Please contact your service center, if the picture has not appeared after a few minutes. No or poor color or poor picture Adjust Color in menu option. [. . . ]