User manual LG 55LM9600

[. . . ] OWNER'S MANUAL LED LCD TV Please read this manual carefully before operating your set and retain it for future reference. LM96** www. lg. com 2 TABLE OF CONTENTS TABLE OF CONTENTS 3 3 4 10 31 31 31 31 MAINTENANCE Cleaning Your TV - Screen, frame, cabinet and stand - Power cord ENGLISH ENG LICENSES OPEN SOURCE SOFTWARE NOTICE SAFETY INSTRUCTIONS Viewing 3D Imaging 31 32 TROUBLESHOOTING SPECIFICATIONS 12 12 12 14 15 16 17 17 18 19 20 INSTALLATION PROCEDURE ASSEMBLING AND PREPARING Unpacking Separate purchase Parts and buttons Lifting and moving the TV Setting up the TV - Attaching the stand - Mounting on a table - Mounting on a wall - Tidying cables 21 21 22 23 23 24 24 25 25 25 26 MAKING CONNECTIONS Antenna connection HDMI connection DVI to HDMI connection MHL connection RGB-PC connection Component connection Composite connection Audio connection - Digital optical audio connection USB connection WARNING If yy you ignore the warning message, you may be seriously injured or there is a possibility of accident or death. 27 28 28 28 MAGIC REMOTE CONTROL FUNCTIONS Registering magic remote control How to use magic remote control Precautions to take when using the magic remote control CAUTION If yy you ignore the caution message, you may be slightly injured or the product may be damaged. 29 30 REMOTE CONTROL USING THE USER GUIDE NOTE The yy note helps you understand and use the product safely. Please read the note carefully before using the product. LICENSES / OPEN SOURCE SOFTWARE NOTICE 3 LICENSES Supported licenses may differ by model. For more information about licenses, visit www. lg. com. [. . . ] The illustrations in this manual may differ from the actual product and item. CAUTION yy not use any unapproved items to ensure the safety and product life span. Do yy damages or injuries by using unapproved items are not covered by the manufacturer's warranty. Any yy Some models have a thin film attached on to the screen and this must not be removed. NOTE yy items supplied with your product may vary depending on the model. The yy Product specifications or contents of this manual may be changed without prior notice due to upgrade of product functions. yy an optimal connection, HDMI cables and USB devices should have bezels less than 10 mm thick and For 18 mm width. Use an extension cable that supports USB 2. 0 if the USB cable or USB memory stick does not fit into your TV's USB port. B A A B 10 mm 18 mm A B ASSEMBLING AND PREPARING 13 ENGLISH ENG P Owner's manual Magic remote control, batteries (AA) (See p. 27) Remote control, batteries (AAA) (See p. 29) Stand body (See p. 17) Stand base (See p. 17) Stand screws 8 EA, M4 x 20 (See p. 17) Composite video cable (See p. 24, 25) Component video cable (See p. 24) Cinema 3D glasses The number of 3D glasses may differ depending on the model or country. or Dual play glasses (Depending on model) Polishing cloth (Depending on model) Use this to remove dust from the cabinet. Isolator (Depending on model) (See p. 14) 14 ASSEMBLING AND PREPARING CAUTION If yy there is a Isolator, follow as shown. » Use this to install TV in a place where there is a voltage difference between TV set and GND of antenna signal. If there is a voltage difference between TV set and GND of antenna signal, the antenna contact might be heated and excessive heat might cause an accident. » You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. It is recommended to mount the isolator to the wall. If it cannot be mounted to the wall, mount it on the TV. Avoid disconnecting the antenna Isolator after installation. » Before starting, be sure that the TV antenna is connected. or ENGLISH ENG Wall ANTENNA/ CABLE IN Cable / Antenna Isolator Connect to Set-Top box. Connect one end of the isolator to cable/antenna jack and the other to TV set or set-top box. "Equipment connected to the protective earthing of the building installation through the mains connection or through other equipment with a connection to protective earthing - and to a cable distribution system using coaxial cable, may in some circumstances create a fire hazard. Connection to a cable distribution system has therefore to be provided through a device providing electrical isolation below a certain frequency range (galvanic isolator, see EN 60728-11)" When applying the RF Isolator, a slight loss of signal sensitivity can occur. Separate purchase Separate purchase items can be changed or modified for quality improvement without any notification. These devices only work with certain models. P AN-MR300 Magic remote control AG-F2**, AG-F3** Cinema 3D glasses AG-F2**DP, AG-F3**DP Dual play glasses The model name or design may be changed depending on the upgrade of product functions, manufacturer's circumstances or policies. ASSEMBLING AND PREPARING 15 Parts and buttons Screen ENGLISH ENG OK SETTNGS INPUT S Speakers Remote control and intelligent sensors Button Adjusts the volume level. Selects the highlighted menu option or confirms an input. Accesses the main menu, or saves your input and exits the menus. [. . . ] yy When the TV is left unattended and unused for a long time, disconnect the power cord from the wall outlet to prevent possible damage from lightning or power surges. Screen, frame, cabinet and stand To remove dust or light dirt, wipe the surface with a dry, clean, and soft cloth. To remove major dirt, wipe the surface with a soft cloth dampened in clean water or a diluted mild detergent. Then wipe immediately with a dry cloth. CAUTION yy Avoid touching the screen at all times, as this may result in damage to the screen. yy not push, rub, or hit the surface with your fingernail or a sharp object, as this may result in Do scratches on the screen and image distortions. [. . . ]