User manual LG 580.54351 400

[. . . ] Do not operate with wet hands to prevent electric shock. If the supply cord is damage, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. strongly recommended to be installed with Earth Leakage Circuit Breaker (ELCB) or Residual Current Device (RCD) to prevent electric shock or fire. This equipment must be earthed to prevent electrical shock or fire. [. . . ] The operation mode priority is given to the first unit that turned on. ⷠDuring operation, heating and cooling mode could not be activated at the same time for different indoor unit. The power indicator blinks to indicate the indoor unit is standing by for different operation mode. Operations could be activated even when the air-conditioner is turned off. In this condition, once e-ion indicator is ON, the unit will operate with AUTO fan speed and air swing. However, this operation could not be activated or will be deactivated if other indoor unit is activating heating mode. Switch off the power supply before cleaning. ⷠDo not touch the aluminium fin, sharp parts may cause injury. Do not use water hotter than 40°C. To ensure optimal performance of the unit, cleaning maintenance have to be carried out at regular intervals. Dirty unit may caused malfunction and you may retrieve error code "H99". For AUTO, the indoor fan speed is automatically adjusted according to the operation mode. Can be activated in all modes and can be cancelled by pressing the respective button again. Detects air quality; e-ion operation activates when air quality is at dirty level. ⷠCan be activated even when the unit is turned off. ⷠPatrol starts automatically with the unit switched on with Can not be activated during "MILD DRY COOLING" operation is activated. tO SET THE TIMER · 2 sets of ON and OFF timers are available to turn ON or OFF the unit at different preset time. ⷠComplete below procedures to set each timer: Generates negative ions to produce fresh air effect and attract dust which will then be captured at the positively charged e-ion filters. ⷠCan be activated even when the unit is turned off. In this condition, fan speed and air swing can not be adjusted. This operation will stop automatically after 20 minutes (For Single Split System). Set the Confirm time Example of application at living room: Morning: ON at 07:00 (Wake up) OFF at 08:00 (Out for work) Evening: ON at 17:00 (Back home) OFF at 22:00 (Sleep) ON To cancel ON or OFF timer, press or OFF to select respective or then press CANCEL. [. . . ] Turn the unit off and reveal the error code to authorized dealer. Use Auto OFF/ON button to select Cooling/Heating operation, after 15 minutes of operation, it is normal to have the following temperature difference between air inlet and air outlet vents: Cooling: 8°C Heating: 14°C Activate Heat mode for 2~3 hours as an alternative to remove moisture left in the internal parts thoroughly to prevent mould growth. ⷠTurn off the power supply. NON SERVICEABLE CRITERIAS TURN OFF POWER SUPPLY then please consult authorized dealer under the following conditions: · These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste. [. . . ]