User manual LG 75259

[. . . ] INSTALLATION The appliance may be used on any rigid horizontal surface. Do not use the same socket for more than one appliance. Make sure the appliance is off before plugging into the mains. The appliance emits a beep and the power indicator light (H) also comes on and remains lit while power to the appliance is on. [. . . ] To activate this function, press the ECO button (D). The unit, will always start at the maximum power. If you want the appliance to distribute the airflow over a larger area, press the oscillation button (C) ( ). The appliance will then oscillate right and left. To stop the oscillation in the desired position, just press oscillation button (C) again. To turn off the appliance press button ON/STAND-BY (A). The display could show the count down for about 6 seconds. To completely turn off the appliance, remove the plug from the socket. NOTE: The display can show the temperature in both °C and °F. To change the temperature scale, press and hold the + key for few seconds, then release. Please be informed that as this is not a precision device, the showed temperature not necessary corresponds to the real one. 24-HOUR DIGITAL TIMER This function can be activated from any operating mode. - Remove the back grille by pulling it outward (Fig. - Remove the dust filter which retains impurities in the air drawn in from the room, blow on it lightly then replace in the appliance. TROUBLE-SHOOTING In case "PF" is displayed and a warning sound is emitted, there is a fault on the temperature sensor. If the problem persists contact the Service Centre. If the appliance shuts off unexpectedly: - Make sure power to the appliance is on. - Make sure the appliance is in a vertical position on a flat surface as otherwise the tip over safety device may have tripped. - Check the temperature set and the timer. The appliance may have gone off because the temperature set has been reached or the time set on the timer has elapsed. IMPORTANT SAFEGUARDS - Do not use this heater near showers, bathtubs, sinks, swimming pools, etc. - Always use the heater in an upright position. Never obstruct the intake and outlet grilles (danger of overheating). [. . . ] The room temperature should be between 030°C (32-86°F). IMPORTANT: To avoid overheating, never under any circumstances cover the appliance during operation as this would lead to a dangerous rise in temperature. WARNING: to avoid the safety system resetting accidentally, this appliance must not be powered through an external on/off device such as a timer, or connected to a circuit which is turned off and on regularly by the energy supplier. Additional safety features - Safety device: The heater is fitted with a safety device which switches it off in the event of accidental overheating (e. g. [. . . ]