User manual LG 78554

[. . . ] You will find your model number on the left hand side wall of the refrigerator. Model # Serial # _ features safety information safEty inforMation · Before operating the appliance, please read this manual thoroughly WARNING and retain it for your reference. WARNING · Because these following operating instructions cover various models, the characteristics of your refrigerator may differ slightly from those described in this manual. CAUTION/WARNING SYMBOLS USED Indicates that a danger of death or serious injury exists. WARNING Indicates that a risk of personal injury or material damage exists. CAUTION OTHER SYMBOLS USED Represents something you must NOT do. Represents something you must NOT disassemble. Represents something you must NOT touch. Indicates that you must disconnect the power plug from the socket. [. . . ] Slowly turn the water filter 90º clockwise to align with the printing mark on the cover, locking the filter in position. Make sure to align the water filter label mark with center of cover filter printing as illustrated. Remember, do not over-tighten. Cover filter separation of red cap align the indication mark with lock position Removing any residual matter inside the water supply line after installing filter. 1. . Press the Water button and push the dispenser pad. Run water through the dispenser until the water runs clear (approx. This will clean the water supply system and remove air from the lines. Additional flushing may be required in some households. Open the refrigerator door and make sure there are no water leaks coming from the water filter. A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation. ice water Check the amount of water supplied to the ice tray. 1. Press the freezer button to set the freezer to your desired temperature. You can set the temperature between -14°C and -25ºC. Press the IceOff button to turn the ice making function off. When Ice Off blinks on the display panel, reinsert the bucket and/or make sure it's installed properly. When you change the filter, press and hold this button for 3 seconds to reset the filter schedule. freezerbutton IceOffbutton lightingbutton fridgebutton Press the lighting button for the dispenser LED lamp to stay on. Press the fridge button to set the fridge to your desired temperature. You can set temperature between 1°C ~ 7°C and Power cool. Power cool will be on the display after 1°C By pressing this button, all buttons will be locked. The Ice Type button and the dispenser pad will not work either. To cancel this function, press this button again. If you are going on vacation or business trip or you do not need to use the refrigerator, press and hold this button for 3 seconds. [. . . ] This is normal and occurs because various accessories are contracting or expanding in relation to the temperature of the refrigerator interior. · Some heat is normal as anti-condensators are installed in the front corners of the refrigerator to prevent condensation. Condensation can occur when you leave the door open for a long time. · Did you wait for 12 hours after installation of the water supply line before making ice? [. . . ]