User manual LG 81623

[. . . ] The user could lose the authority to operate this equipment if an unauthorized change or modification is made. REGULATORY INFORMATION: FCC Part 15 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. [. . . ] Using the template as a guide, make a hole through the ceiling. Pass the connection cable through the inner side of the ceiling. 12 Installation 3. Install the camera mounting bracket to the ceiling. Connect the cables to the cable jacks of the camera body. 13 Installation 5. Assemble the camera and mounting bracket. Connect the unit by following step a and b. 6. Turn the dome cover to adjust the camera view point . 14 Installation Image Adjustment You can manually adjust the pan/tilt/azimuth angles, focus, and zoom while observing the connected monitor. Notes: Do not hold the camera by lens unit to adjust panning, tilting, or azimuth. The video output to the BNC will be interrupted while a portable monitor is connected to the video jack. Connect a portable monitor to the video jack. 15 Installation 3. Adjust the pan/tilt position of the camera. Lock the pan/tilt lock screw after adjusting. AREA SETTING: Use [LEFT] or [RIGHT] button to select a area then use [UP] or [DOWN] button to select a [ON] or [OFF]. Press [SET] to exit the Area setting menu. > GRAY SCALE: Use [LEFT] or [RIGHT] button to select a gray scale. (GRAY, D. GRAY, BLACK) > USER SCALE: Use [LEFT] or [RIGHT] button to select a bright level. (5 level) > MASK: Use [LEFT] or [RIGHT] button to select [ON] or [OFF]. If you set the MASK to ON, the mask function is activate only when the HSBLC is automatically activated in low luminance scene. > BRIGHTNESS setting You can increase the brightness of the darkened video. If you set the brightness to lower value, the image is darkened. If you set the brightness to higher value, the image gets bright. 1. Use [LEFT] or [RIGHT] button to set the bright level. 23 Menu Operation AGC (Automatic Gain Control) setting If the images are too dark, change the maximum [AGC] value to make the images brighter. SHUTTER (Shutter Speed) setting Select the desired shutter speed for camera exposure. You can change the shutter speed to higher speed to capture fast-moving subjects, though the image becomes darker. 1. [. . . ] If you set to lower value, the image outline becomes dim. 30 Menu Operation STABILIZER setting Setting the D-ZOOM (Digital Zoom ) level You can select the digital zoom level. The image stabilizer function minimizes the appearance of shaky images caused by low-frequency vibration. This function is useful for outdoor surveillance. Select [STABILIZER] option and set to ON or OFF. Note: If you set the [STABILIZER] to ON, the Digital zoom is set to [x1. 1] automatically. 1. [. . . ]