User manual LG AC209I

[. . . ] x This unit contains no user-serviceable parts. Always consult authorized service personnel for repairs. x When moving, consult authorized service personnel for disconnection and installation of the unit. x Do not become over-exposed to cold air by staying in the direct path of the airflow of the air conditioner for extended periods of time. [. . . ] x Blinking of the timer indicator stops. x The selected mode and the temperature disappear on the display after 5 seconds. x The air conditioner will switch on automatically when the counter displayed on the remote controller reaches the setting time as disappearing the On timer setting. Note You can see or change the setting mode and/or the temperature by pressing the Mode button or the Temperature buttons after setting the On timer. To Cancel the On Timer 1 To cancel the On Timer, press the On Timer button one or more times until the On timer setting disappears. 2 Press the (Set/Cancel) button. Note If you want to turn on the air conditioner before the timer reaches the setting time, press the (ON/OFF) button. E-18 Setting the Off Timer ENGLISH The Off Timer enables you to switch off the air conditioner automatically after a given period of time. You can set the period of time from 30 minutes to 24 hours. 1 To set the operating time, press the Off Timer button one or more times until the required time is displayed. Possible time is between 0. 5 hour and 24 hour inclusive. Result: x Each time you press Off Timer button: - The time is adjusted by 0. 5 hour to 5 hours, by 1 hour from 6 hours to 24 hours. 2 Press the (Set/Cancel) button to complete the setting. Result: x The remaining time is displayed. x Blinking of the timer indicator stops. x The selected mode and the temperature disappear on the display after 5 seconds. x The air conditioner will switch off automatically when the counter displayed on the remote controller reaches the setting time as disappearing the Off timer setting. You can change modes at any time. is displayed Note 3 To adjust the temperature, press the Temperature buttons one or more times until the required temperature is displayed. Possible temperatures are between 18OC and 30OC inclusive. Result: x Each time you press Temperature buttons: - The temperature is adjusted by 1OC. - The receiver & display unit beeps. x The air conditioner starts cooling, provided that the room x temperature is higher than the selected temperature ; the fan x will, however, operate. 4 Select the fan speed by pressing the Fan button one or more times until the intended value is displayed : Automatic(rotated : Low Medium High ) E-22 Heating Your Room ENGLISH You must select the HEAT mode if you wish to adjust the : x Heating temperature x Fan speed when heating 1 If necessary, press Result: x x x x (ON/OFF) button. The On/Off indicator on the receiver & display unit comes on. The air conditioner runs in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped lt will start up normally after three minutes. IMPORTANT 2 To select the HEAT mode, press the Mode button until at the top of the wireless remote controller. Result: x The receiver & display unit beeps. x The air conditioner runs in HEAT mode. You can change modes at any time. is displayed Note 3 To adjust the temperature, press the Temperature buttons one or more times until the required temperature is displayed. Possible temperatures are between 16OC and 30OC inclusive. [. . . ] IMPORTANT Before cleaning your air conditioner, ensure that you have switched off the electric circuit breaker used for the unit. 1 Turn the levers to the right or left not to prevent pulling out the air filter. 2 Pull out the air filter depending on your installation. 3 Remove all dust on air filter with a vacuum cleaner or a brush. In case of serious dust accumulation, put the air filter in warm detergent water and shake it vertically. When you have finished, insert the filter into the unit. 4 * The location of the air filter may differ from this figure depending on your installation. 5 6 Return the levers. 7 Clean the outdoor unit with a vacuum cleaner or a brush once a month. Note After cleaning the air conditioner, press the Filter Reset button. Wired Remote Controller Wireless Remote Controller E-30 Cleaning Your Air Conditioner(optional) ADH4400G/DH44ZA1(A2) ENGLISH To get the best possible use out of your air conditioner, you must clean it regularly to remove the dust that accumulates on the air filter. The air filter is an optional accessory. [. . . ]