User manual LG AF993W

[. . . ] Use the attached RGB cable and the shielded LAN cable with this equipment so as to keep interference within the limits of an FCC Class B device. DO NOT LOOK DIRECTLY INTO THE LENS WHEN THE PROJECTOR IS IN THE POWER ON MODE. CAUTION Not for use in a computer room as defined in the Standard for the Protection of Electronic Computer/ Data Processing Equipment, ANSI/NFPA 75. The attached power cord is to be used exclusively for this product. [. . . ] Adjust Shutter(U) or Shutter(L) in the Signal-User menu. Press the or button to select a setting to adjust. Adjust the selected setting by pressing the or button. · Do not change the settings of the Signal menu for ordinary use. LPF (Progressive filter) You can select to enable or disable the LPF. Vertical or horizontal streaks may appear in the projected image, depending on the type of the DVD player, game console or computer in use. If this occurs, reduce noise by enabling the LPF. Projected images appear slightly faint. EN-32 Network settings You can set the network of the projector using the menu. Network Config Projector Name Network Certification Network Password IP Config Wireless Setting AMX Device Discovery Network Initialization Network Restart Adjust Select SET On OK OK OK Off OK OK MENU Exit Enabling or disabling the network certification You can select whether or not to certify the network communication using the network password. Press the or button to select Network Certification. Network Certification On 3. · Certification dialog appears. Setting Projector Name (See page 21 for menu setting. ) 1. Press the or button to select Projector Name. Projector Name SET 3. · PROJECTOR NAME screen appears. 4. DEL key: Deleting the character in the position of enter cursor for each character. caps/CAPS key: Switching an alphabet character to CAPITAL or small. CLEAR key: Deleting all the entered characters. · The default password is "admin". Network settings (continued) 5. Select OK, and NEW NETWORK PASSWORD screen appears if the entered password is correct. · If the entered password is not correct, CURRENT NETWORK PASSWORD screen appears again. IP Config settings (See page 21 for menu setting. ) 1. Press the or button to select IP Config. IP Config OK 3. · IP Config menu appears. IP Config DHCP IP Address Subnet Mask On 169 - 254 255 - 255 169 - 254 Off 169 - 254 - 0 - 221 0 0 0 - 220 - 6. Enter the NEW NETWORK PASSWORD and CONFIRM NETWORK PASSWORD. · Password can be set using up to 32 characters including alphabets (capital/small) or numeric characters. key: Shifting the position of enter cursor to the left for each character. [. . . ] If the above solution is not effective, replace the lamp. Steady green Blinking green/red The lamp operation time exceeds the time elapsed until the lamp lifetime notice while the power is on. (See page 51. ) The lamp operation time exceeds the time elapsed until the lamp lifetime notice while the power is off. (See page 51. ) The lamp operation time exceeds the time elapsed until the lamp lifetime. (See page 51. ) The lamp cover isn't closed. Replace the lamp. [. . . ]